Re: [PATCH v4] PCI/AER: Enable error reporting for all ports

[Keith Busch]

On Thu, Oct 18, 2018 at 03:53:58PM -0500, Bjorn Helgaas wrote:
> Change the AER service driver so it binds to *all* PCIe Ports, including
> Switch Upstream and Downstream Ports.  Enable AER error reporting for all
> these Ports, but not for any children.

I'm looking at this again and think enabling/disabling error reporting for
ports is the responsibility of the port driver, not the AER service.

The following should do the same as this patch, but without making AER
driver handle non-root ports.  The report enabling/disabling functions
are already stubbed for '!CONFIG_PCIE_AER' and have checks for aer_cap
and firmware first.

A real patch for this could even make this remove all the aer specific
error report enabling, so it'd be a net-loss in code lines. :)

---
diff --git a/drivers/pci/pcie/portdrv_pci.c b/drivers/pci/pcie/portdrv_pci.c
index 0acca3596807..f129a33c8303 100644
--- a/drivers/pci/pcie/portdrv_pci.c
+++ b/drivers/pci/pcie/portdrv_pci.c
@@ -122,12 +122,13 @@ static int pcie_portdrv_probe(struct pci_dev *dev,
 		pm_runtime_put_autosuspend(&dev->dev);
 		pm_runtime_allow(&dev->dev);
 	}
-
+	pci_enable_pcie_error_reporting(dev);
 	return 0;
 }
 
 static void pcie_portdrv_remove(struct pci_dev *dev)
 {
+	pci_disable_pcie_error_reporting(dev);
 	if (pci_bridge_d3_possible(dev)) {
 		pm_runtime_forbid(&dev->dev);
 		pm_runtime_get_noresume(&dev->dev);
--