Re: [PATCH v2 1/4] nfc: pn533: add UART phy driver

From: Lars Poeschel
Date: Fri Oct 19 2018 - 04:57:42 EST


On Thu, Oct 18, 2018 at 05:00:28PM +0200, Marcel Holtmann wrote:
> Hi Lars,
>
> > This adds the UART phy interface for the pn533 driver.
> > The pn533 driver can be used through UART interface this way.
> > It is implemented as a serdev device.
> >
> > Signed-off-by: Lars Poeschel <poeschel@xxxxxxxxxxx>
> > ---
> > Changes in v2:
> > - switched from tty line discipline to serdev, resulting in many
> > simplifications
> > - SPDX License Identifier
> >
> > drivers/nfc/pn533/Kconfig | 10 ++
> > drivers/nfc/pn533/Makefile | 2 +
> > drivers/nfc/pn533/pn533.h | 8 ++
> > drivers/nfc/pn533/uart.c | 283 +++++++++++++++++++++++++++++++++++++
> > 4 files changed, 303 insertions(+)
> > create mode 100644 drivers/nfc/pn533/uart.c
> >
> > diff --git a/drivers/nfc/pn533/Kconfig b/drivers/nfc/pn533/Kconfig
> > index d94122dd30e4..da3ea2dbaa8a 100644
> > --- a/drivers/nfc/pn533/Kconfig
> > +++ b/drivers/nfc/pn533/Kconfig
> > @@ -25,3 +25,13 @@ config NFC_PN533_I2C
> >
> > If you choose to build a module, it'll be called pn533_i2c.
> > Say N if unsure.
> > +
> > +config NFC_PN532_UART
> > + tristate "NFC PN532 device support (UART)â
>
> you are missing the "depends on SERIAL_DEV_BUSâ here.

Yes, absolutely right. I missed that. I will post a follow-up.

BTW a question:
Only enabling SERIAL_DEV_BUS did not suffice for me. I also had to
enable SERIAL_DEV_CTRL_TTYPORT, otherwise the probe of the driver was
not called. This seems a bit odd to me. This option seems unrelated, but
without it, it did not work.

Should I better depend on SERIAL_DEV_CTRL_TTYPORT then ?

Thanks,
Lars