Re: [RFC PATCH 0/3] M_CAN Framework rework
From: Faiz Abbas
Date: Wed Oct 24 2018 - 03:31:38 EST
Hi Dan,
On Thursday 18 October 2018 01:51 AM, Dan Murphy wrote:
> Bump
>
> On 10/10/2018 09:20 AM, Dan Murphy wrote:
>> All
>>
>> This patch series creates a m_can core framework that devices can register
>> to. The m_can core manages the Bosch IP and CAN frames. Each device that
>> is registered is responsible for managing device specific functions.
>>
>> This rewrite was suggested in a device driver submission for the TCAN4x5x
>> device
>> Reference upstream post:
>> https://lore.kernel.org/patchwork/patch/984163/
>>
>> For instance the TCAN device is a SPI device that uses a specific data payload to
>> determine writes and reads. In addition the device has a reset input as well
>> as a wakeup pin. The register offset of the m_can registers differs and must
>> be set by the device attached to the core.
>>
>> The m_can core will use iomapped writes and reads as the default mechanism for
>> writing and reading. The device driver can provide over rides for this.
>>
>> This patch series is not complete as it does not handle the CAN interrupts
>> nor can perform a CAN write. If this patch series is deemed acceptable I will
>> finish debugging the driver and post a non RFC series.
>>
>> Finally I did attempt to reduce the first patch with various git format patch
>> directives but none seemed to reduce the patch.
>>
>> Dan
>>
>> Dan Murphy (3):
>> can: m_can: Create m_can core to leverage common code
>> dt-bindings: can: tcan4x5x: Add DT bindings for TCAN4x5X driver
>> can: tcan4x5x: Add tcan4x5x driver to the kernel
>>
>> .../devicetree/bindings/net/can/tcan4x5x.txt | 34 +
>> drivers/net/can/m_can/Kconfig | 18 +
>> drivers/net/can/m_can/Makefile | 4 +-
>> drivers/net/can/m_can/m_can.c | 1683 +----------------
>> .../net/can/m_can/{m_can.c => m_can_core.c} | 479 +++--
>> drivers/net/can/m_can/m_can_core.h | 100 +
>> drivers/net/can/m_can/tcan4x5x.c | 321 ++++
>> 7 files changed, 722 insertions(+), 1917 deletions(-)
>> create mode 100644 Documentation/devicetree/bindings/net/can/tcan4x5x.txt
>> copy drivers/net/can/m_can/{m_can.c => m_can_core.c} (83%)
>> create mode 100644 drivers/net/can/m_can/m_can_core.h
>> create mode 100644 drivers/net/can/m_can/tcan4x5x.c
>>
Patch 1/3 never arrived for me. Its not there on lkml either.
https://lkml.org/lkml/2018/10/10/611
Can you resend the complete series?
Thanks,
Faiz