Re: [PATCH] zynq-fpga: Only route PR via PCAP when required

[Moritz Fischer]

Hi Michal,

On Fri, Oct 26, 2018 at 12:54 AM Michal Simek <michal.simek@xxxxxxxxxx> wrote:

> > Ok, I had suspected you tested it and probably didn't run into issues,
> > but just wanted to make sure we think about it. If you don't mind, swap
> > it around as I suggested just to be safe.
> >
> > With that change feel free to add my Reviewed-by: Moritz Fischer
> > <mdf@xxxxxxxxxx> in your v2.
>
> That clock can be used by something else that's why you didn't observe
> any issue. Anyway I have no problem with reverting that setting back
> that icap can be used.

Ok, thanks for clarification, that was what I assumed :)

> In general there should be synchronization mechanism for this. And also
> driver "feature" not to enable access from icap for security reason. But
> that's something what should be done in other patch.

Yeah I'll have to look at remote notifications for FPGA managers
soon-ish for another
project as discussed at ELCE. Part of that would be synchronization I guess :)

Umhh, based on the secure state read from CTRL_SEC_EN bit, or did you
think along the
lines of "xlnx,no-icap" property that your bootloader / dt would provide?

Cheers,

Moritz