Re: [PATCH] USB: Don't enable LPM if it's already enabled

[Mathias Nyman]

On 30.10.2018 07:54, Kai-Heng Feng wrote:
> USB Bluetooth controller QCA ROME (0cf3:e007) sometimes stops working
> after S3:
> [ 165.110742] Bluetooth: hci0: using NVM file: qca/nvm_usb_00000302.bin
> [ 168.432065] Bluetooth: hci0: Failed to send body at 4 of 1953 (-110)
>
> After some experiments, I found that disabling LPM can workaround the
> issue.
>
> On some platforms, the USB power is cut during S3, so the driver uses
> reset-resume to resume the device. During port resume, LPM gets enabled
> twice, by usb_reset_and_verify_device() and usb_port_resume().
>
> So let's enable LPM for just once, as this solves the issue for the
> device in question.
>
> Signed-off-by: Kai-Heng Feng <kai.heng.feng@xxxxxxxxxxxxx>
> ---
>   drivers/usb/core/driver.c | 3 ++-
>   1 file changed, 2 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/usb/core/driver.c b/drivers/usb/core/driver.c
> index 53564386ed57..e11d2eac76b6 100644
> --- a/drivers/usb/core/driver.c
> +++ b/drivers/usb/core/driver.c
> @@ -1901,7 +1901,8 @@ int usb_set_usb2_hardware_lpm(struct usb_device *udev, int enable)
>   	struct usb_hcd *hcd = bus_to_hcd(udev->bus);
>   	int ret = -EPERM;
>   
> -	if (enable && !udev->usb2_hw_lpm_allowed)
> +	if (enable && !udev->usb2_hw_lpm_allowed ||
> +	    udev->usb2_hw_lpm_enabled == enable)
>   		return 0;
>   
>   	if (hcd->driver->set_usb2_hw_lpm) {

Something like that would probably work.

Would it make sense to skip USB2 hw LPM enabling in usb_port_resume() if
port was just reset (and thus LPM enabled)?

something like this:

--- a/drivers/usb/core/hub.c
+++ b/drivers/usb/core/hub.c
@@ -3520,7 +3520,7 @@ int usb_port_resume(struct usb_device *udev, pm_message_t msg)
                hub_port_logical_disconnect(hub, port1);
        } else  {
                /* Try to enable USB2 hardware LPM */
-               if (udev->usb2_hw_lpm_capable == 1)
+               if (udev->usb2_hw_lpm_capable == 1 && !udev->reset_resume)
                        usb_set_usb2_hardware_lpm(udev, 1);
 
                /* Try to enable USB3 LTM */

-Mathias