Re: [RCF PATCH,v2,2/2] pwm: imx: Configure output to GPIO in disabled state

[Lothar WaÃmann]

Uwe Kleine-KÃnig <u.kleine-koenig@xxxxxxxxxxxxxx> wrote:

> Hello Thierry,
> 
> On Thu, Nov 15, 2018 at 04:25:45PM +0100, Thierry Reding wrote:
> > On Wed, Nov 14, 2018 at 10:51:20PM +0100, Uwe Kleine-KÃnig wrote:  
> > > On Wed, Nov 14, 2018 at 12:34:49PM +0100, Thierry Reding wrote:  
[...]
> > > Also dts writes don't need to lookup the needed GPIO numbers and pinctrl.  
> > 
> > Just to clarify: I don't think that we need to get the GPIO number
> > involved in this case, because we don't have to reconfigure the pin as
> > GPIO to make this work. The only reason that Michal's proposal did that
> > is because that was believed to be necessary. But if the pin can just be
> > configured with a 100k pull-up, that's enough to pull the pin high when
> > we need it.  
> 
> Unless the gpio happens to be configured as output at the wrong value.
> Further I'm not sure if the pwm in disabled state actively pulls to 0
> and if in this state the PU of the pin is good enough to ensure a one
> here. That would need verification first.
> 
No. You can disable the output driver via pinctrl, so that only the
selected pull-up/down is relevant. The pin function and GPIO register
settings don't matter at all in this case.


Lothar WaÃmann
-- 
___________________________________________________________

Ka-Ro electronics GmbH | PascalstraÃe 22 | D - 52076 Aachen
Phone: +49 2408 1402-0 | Fax: +49 2408 1402-10
GeschÃftsfÃhrer: Matthias Kaussen
Handelsregistereintrag: Amtsgericht Aachen, HRB 4996

www.karo-electronics.de | info@xxxxxxxxxxxxxxxxxxx
___________________________________________________________