Re: [ARM64] Printing IRQ stack usage information

[Pintu Agarwal]

On Sat, Nov 17, 2018 at 12:02 AM <valdis.kletnieks@xxxxxx> wrote:
>
> On Fri, 16 Nov 2018 23:13:48 +0530, Pintu Agarwal said:
> > On Fri, Nov 16, 2018 at 10:16 PM <valdis.kletnieks@xxxxxx> wrote:
>
> > > Congrats. You just re-invented DEBUG_STACK_USAGE, which just keeps a high-water mark
> > > for stack usage.
> >
> > So, you mean to say, my implementation is good enough to get the
> > irq_stack usage, from the interrupt handler ?
>
> No - your code doesn't keep a high-water mark (which should probably be
> hooked into the IRQ exit code.
>
> > But my concern is that if I dump it from irq handler, I will get
> > information only for the current cpu.
> > How do I store and get the information for all the cpu from the boot time ?
>
> Make the high-water mark a per-cpu variable.
>
> > From where do I call my dump_irq_stack_info() [some where during the
> > entry/exit part of the irq handler], so that I could dump information
> > for all the handler at boot time itself ?
>
> No, you don't do a dump-stack during entry/exit.  You just maintain a high-water
> value in the exit,

Which is the right place to keep track of this
high-water-irq-stack-usage (per_cpu)
in arch/arm64/* ?

> and then you create a /proc/something or similar that when
> read does a 'foreach CPU do print_high_water_irq'.
>
Ok got it.

> > Like I would to capture these information:
> > - What was the name of the handler ?
> > - Which cpu was executing it ?
> > - How much irq stack (max value, same like high water mark) were used
> > at that time ?
>
> First, do the easy part and find out if you even *care* once you see actual
> numbers.  If your IRQ stack is 8K but you never use more than 2500 bytes,
> do you *really* care about the name of the handler anymore?
>

Hmm, yes, getting the name of the handler is not so important in the first run.

> Also, see the code for /proc/interrupts to see how it keeps track of the
> interrupts per CPU - maybe all you need to do is change each entry from
> a 'count' to 'count, highwater'.

Ok thanks, thats a good pointer.