[PATCH v3 1/4] dt: thermal: tsens: Add bindings for qcs404

[Amit Kucheria]

qcs404 uses v1 of the TSENS IP block. Create a fallback DT property
"qcom,tsens-v1" to gather common code.

Signed-off-by: Amit Kucheria <amit.kucheria@xxxxxxxxxx>
Reviewed-by: Vinod Koul <vkoul@xxxxxxxxxx>
Tested-by: Vinod Koul <vkoul@xxxxxxxxxx>
---
 Documentation/devicetree/bindings/thermal/qcom-tsens.txt | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/Documentation/devicetree/bindings/thermal/qcom-tsens.txt b/Documentation/devicetree/bindings/thermal/qcom-tsens.txt
index 1d9e8cf61018..799de3062352 100644
--- a/Documentation/devicetree/bindings/thermal/qcom-tsens.txt
+++ b/Documentation/devicetree/bindings/thermal/qcom-tsens.txt
@@ -8,9 +8,12 @@ Required properties:
     - "qcom,msm8996-tsens" (MSM8996)
     - "qcom,msm8998-tsens", "qcom,tsens-v2" (MSM8998)
     - "qcom,sdm845-tsens", "qcom,tsens-v2" (SDM845)
+    - "qcom,qcs404-tsens", "qcom,tsens-v1" (QCS404)
   The generic "qcom,tsens-v2" property must be used as a fallback for any SoC
   with version 2 of the TSENS IP. MSM8996 is the only exception because the
   generic property did not exist when support was added.
+  Similarly, the generic "qcom,tsens-v1" property must be used as a fallback for
+  any SoC with version 1 of the TSENS IP.
 
 - reg: Address range of the thermal registers.
   New platforms containing v2.x.y of the TSENS IP must specify the SROT and TM
-- 
2.17.1