Re: [PATCH anybus v4 6/7] dt-bindings: anybuss-host: document devicetree binding

[Rob Herring]

On Wed, Nov 28, 2018 at 9:38 AM Sven Van Asbroeck <thesven73@xxxxxxxxx> wrote:
>
> Rob, thank you so much for the review !
>
> On Mon, Nov 26, 2018 at 5:08 PM Rob Herring <robh@xxxxxxxxxx> wrote:
>
> > Unit-addresses are based on 'reg'. So this should either be '89' or
> > based on a definition for the bus (e.g. PCI uses dev and func).
> >
> >> +                     reg = <0x0089>;
> >
> > Is fieldbus type how one addresses a device on the bus?
>
> I'm afraid not. Anybus cards don't have an address, because only a single card
> can be connected to an anybus at a time.

Then you don't need reg as you should only have 1 child node.

> Fieldbus type defines the type/functionality of the connected card. Like pci
> device ids.

Which for PCI can be overridden in DT, but is part of reg.

> The current patchset allows devicetree nodes to be provided depending on
> the type of card connected to the bus. It identifies the card by type,
> not location.
>
> Is this not desired / allowed ?

No, 'reg' is how you address a device. You could use 'type' in the
compatible string if type implies some sort of standard class
interface.

> > I'm still not clear what a bridge vs. host is. Both examples are on WEIM
> > bus CS0?
>
> I agree that the terminology is too confusing. I'm looking to change it.
>
> Let's compare current anybus with a well-established bus architecture like pci:
>
>                                 pci                     anybus
> --------------------------------------------------------------------------------
> Common bus code (spec),         pci/pci_driver.c        fieldbus/anybuss-host.c
>   calls bus_register()                                  must be parallel bus
>                                                         subnode
>                                 no of compatible        has of compatible
> --------------------------------------------------------------------------------
> Device on bus, calls
>   XXX_client_driver_register()  hwmon/k8temp.c          fieldbus/hms-profinet.c
> --------------------------------------------------------------------------------
> Controller, silicon driver      pci/pcie-tango.c        fieldbus/anybus-bridge.c
>                                 platform_driver calls   platform_driver does not
>                                 pci_host_probe()        register with anybus
>
> I should probably rework this so it conforms more closely to the way it's done
> on pci. Would the following look any better?

Yes, this looks better.

>                                 pci                     anybus
> --------------------------------------------------------------------------------
> Common bus code (spec),         pci/pci_driver.c        anybus/anybus_driver.c

Maybe just anybus/core.c or anybus/bus.c. I'm guessing your
implementation will be *much* more simple than PCI.

>   calls bus_register()          no of compatible        no of compatible
> --------------------------------------------------------------------------------
> Device on bus, calls
>   XXX_client_driver_register()  hwmon/k8temp.c          fieldbus/hms-profinet.c
> --------------------------------------------------------------------------------
> Controller, silicon driver      pci/pcie-tango.c        anybus/arcx-controller.c
>                                 platform_driver calls   platform_driver calls
>                                 pci_host_probe()        anybus_host_probe()
>
> Of course, the analogy is not perfect, as there can only be a single card
> (device) connected to an anybus at a time.

Right, that should simplify the bus code a lot.

Rob