Re: [PATCH v2] block: Change to use DEFINE_SHOW_ATTRIBUTE macro

From: Frank Lee
Date: Sat Dec 01 2018 - 13:59:31 EST


On Sun, Dec 2, 2018 at 2:38 AM Jens Axboe <axboe@xxxxxxxxx> wrote:
>
> On 12/1/18 11:31 AM, Frank Lee wrote:
> > On Sun, Dec 2, 2018 at 2:11 AM Jens Axboe <axboe@xxxxxxxxx> wrote:
> >>
> >> On 12/1/18 7:24 AM, Yangtao Li wrote:
> >>> Use DEFINE_SHOW_ATTRIBUTE macro to simplify the code.
> >>>
> >>> Signed-off-by: Yangtao Li <tiny.windzz@xxxxxxxxx>
> >>> ---
> >>> changes in v2:
> >>> -Modify some function names to avoid compilation errors
> >>
> >> The fact that your previous patch didn't even compile doesn't fill me
> >> with a lot of confidence in the amount of diligence and testing
> >> you apply to your patches.
> >>
> >> Why would you send something out that you didn't even compile?
> >>
> >> --
> >> Jens Axboe
> >>
> > These changes are the same and only require a small change.
> > Most of the changes are fine, so it's a bit negligent.
>
> When someone is sending a patch for inclusion, at the very minimum
> I expect it to have been compiled, and preferably tested too. Doesn't
> matter how small the change is, even a one-liner should go through that.
>
> That said, I'm not a huge fan of changes like this. It completely
> hides what is going on for someone reading the code, and it's not
> like there's a win on code size for example. The only win seems to
> be that driver writes can't mess it up, which is a nice benefit.
>
> --
> Jens Axboe
>
Yeah,you are right.Can you review it?

Yours,
Yangtao