Re: [PATCH v5 0/7] spi: add support for octal mode

[Boris Brezillon]

On Thu, 6 Dec 2018 04:20:26 +0000
Yogesh Narayan Gaur <yogeshnarayan.gaur@xxxxxxx> wrote:

> Hi Boris,
> 
> > -----Original Message-----
> > From: Boris Brezillon [mailto:boris.brezillon@xxxxxxxxxxx]
> > Sent: Wednesday, December 5, 2018 6:16 PM
> > To: Vignesh R <vigneshr@xxxxxx>; broonie@xxxxxxxxxx
> > Cc: Yogesh Narayan Gaur <yogeshnarayan.gaur@xxxxxxx>; linux-
> > mtd@xxxxxxxxxxxxxxxxxxx; marek.vasut@xxxxxxxxx; linux-spi@xxxxxxxxxxxxxxx;
> > devicetree@xxxxxxxxxxxxxxx; robh@xxxxxxxxxx; mark.rutland@xxxxxxx;
> > shawnguo@xxxxxxxxxx; linux-arm-kernel@xxxxxxxxxxxxxxxxxxx;
> > computersforpeace@xxxxxxxxx; frieder.schrempf@xxxxxxxxx; linux-
> > kernel@xxxxxxxxxxxxxxx
> > Subject: Re: [PATCH v5 0/7] spi: add support for octal mode
> > 
> > On Wed, 5 Dec 2018 17:25:12 +0530
> > Vignesh R <vigneshr@xxxxxx> wrote:
> >   
> > > >>   mtd: spi-nor: add opcodes for octal Read/Write commands
> > > >>   mtd: spi-nor: add octal read flag for flash mt35xu512aba  
> > >
> > > Could you consider merging these two patches alone for v4.21?
> > > These can be applied independent of other patches in the series and
> > > would allow supporting OSPI flash at SPI NOR level with Cadence QSPI driver.  
> > 
> > Yep, I'll queue them to spi-nor/next.
> >   
> > > >>   spi: nxp-fspi: add octal mode flag bit for octal support  
> > 
> > Mark, I think you can pick this one too.  
> 
> This patch is dependent on the series [1] which is yet to be applied by you, please apply.

By me? I can't apply SPI patches.