RE: [PATCH] PCI: Enable SERR# forwarding for Type-1 PCI devices

From: Bharat Kumar Gogada
Date: Thu Dec 06 2018 - 10:47:31 EST


Hi All,

Please let me know if anyone has any issue with this patch.

Regards,
Bharat
> As per Figure 6-3 in PCIe r4.0, sec 6.2.6, ERR_ messages will be forwarded
> from the secondary interface to the primary interface, if the SERR# Enable
> bit in the Bridge Control register is set.
> Currently PCI_BRIDGE_CTL_SERR is being enabled only in ACPI flow.
> This patch enables PCI_BRIDGE_CTL_SERR for Type-1 PCI device.
>
> Signed-off-by: Bharat Kumar Gogada <bharat.kumar.gogada@xxxxxxxxxx>
> ---
> drivers/pci/probe.c | 20 ++++++++++++++++++--
> 1 file changed, 18 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c index
> b1c05b5..ed71e8e 100644
> --- a/drivers/pci/probe.c
> +++ b/drivers/pci/probe.c
> @@ -1841,8 +1841,6 @@ static void program_hpp_type0(struct pci_dev
> *dev, struct hpp_type0 *hpp)
> pci_write_config_byte(dev, PCI_SEC_LATENCY_TIMER,
> hpp->latency_timer);
> pci_read_config_word(dev, PCI_BRIDGE_CONTROL,
> &pci_bctl);
> - if (hpp->enable_serr)
> - pci_bctl |= PCI_BRIDGE_CTL_SERR;
> if (hpp->enable_perr)
> pci_bctl |= PCI_BRIDGE_CTL_PARITY;
> pci_write_config_word(dev, PCI_BRIDGE_CONTROL,
> pci_bctl); @@ -2114,6 +2112,23 @@ static void
> pci_configure_eetlp_prefix(struct pci_dev *dev) #endif }
>
> +static void pci_configure_serr(struct pci_dev *dev) {
> + if (dev->hdr_type == PCI_HEADER_TYPE_BRIDGE) {
> + u16 control;
> +
> + /*
> + * A Type-1 PCI bridge will not forward ERR_ messages
> coming
> + * from an endpoint if SERR# forwarding is not enabled.
> + */
> + pci_read_config_word(dev, PCI_BRIDGE_CONTROL,
> &control);
> + if (!(control & PCI_BRIDGE_CTL_SERR)) {
> + control |= PCI_BRIDGE_CTL_SERR;
> + pci_write_config_word(dev, PCI_BRIDGE_CONTROL,
> control);
> + }
> + }
> +}
> +
> static void pci_configure_device(struct pci_dev *dev) {
> struct hotplug_params hpp;
> @@ -2124,6 +2139,7 @@ static void pci_configure_device(struct pci_dev
> *dev)
> pci_configure_relaxed_ordering(dev);
> pci_configure_ltr(dev);
> pci_configure_eetlp_prefix(dev);
> + pci_configure_serr(dev);
>
> memset(&hpp, 0, sizeof(hpp));
> ret = pci_get_hp_params(dev, &hpp);
> --
> 2.7.4