Re: [PATCH] USB: quirks: add NO_LPM quirk for Logitech Flare|Meetup|Brio|Rally

[Mathias Nyman]

On 08.12.2018 00:18, Kyle Williams wrote:
> On Tue, Dec 04, 2018 at 04:36:18PM -0500, Alan Stern wrote:
> > On Tue, 4 Dec 2018, Kyle Williams wrote:
> >
> > > Description: Some USB device / host controller combinations seem to have
> > > problems with Link Power management. In particular it is described that
> > > the combination of certain Logitech devices and other powered media
> > > devices such as the Atrus device causes 'not enough bandwidth for
> > > new device state'error.
> > >
> > > This patch creates quirk entries for the tested Logitech device
> > > indicating LPM should remain disabled for the device.
> > >
> > > Signed-off-by: Kyle Williams <kdgwill@xxxxxxxxxxxx>
> > > ---
> > >   drivers/usb/core/quirks.c | 16 ++++++++++++++++
> > >   1 file changed, 16 insertions(+)
> > >
> > > diff --git a/drivers/usb/core/quirks.c b/drivers/usb/core/quirks.c
> > > index 0690fcff0ea2..9403edee4797 100644
> > > --- a/drivers/usb/core/quirks.c
> > > +++ b/drivers/usb/core/quirks.c
> > > @@ -246,6 +246,22 @@ static const struct usb_device_id usb_quirk_list[] = {
> > >          /* Logitech Harmony 700-series */
> > >          { USB_DEVICE(0x046d, 0xc122), .driver_info = USB_QUIRK_DELAY_INIT },
> > >
> > > +       /* Logitech Flare */
> > > +       { USB_DEVICE(0x046d, 0x0876), .driver_info = USB_QUIRK_NO_LPM },
> >
> > This entry is out of order with the preceding entry.  And some of the
> > new entries below are out of order with each other (entries are
> > supposed to be sorted by Vendor ID, then Product ID).
> >
> > Also, perhaps instead of adding all these new entries, we should set
> > the NO_LPM quirk flag for all Logitech devices?
> >
> > Alan Stern
> Setting USB_QUIRK_NO_LPM for all Logitech devices instead of specific
> ones seem to be a better solution as there are a lot of other devices
> that have the issue as well
>
> Kyle Williams

I recently found a cause for the "not enough bandwidth for new device state" error.
Patch just got applied to v4.20-rc6
0472bf0 xhci: Prevent U1/U2 link pm states if exit latency is too long

Does it work for your Logitech devices?

-Mathias