Re: [PATCH] eint: add gpio vritual number select

[Sean Wang]

On Thu, Dec 13, 2018 at 1:36 AM <chuanjia.liu@xxxxxxxxxxxx> wrote:
>
> From: Chuanjia Liu <Chuanjia.Liu@xxxxxxxxxxxx>
>
> This patch add gpio vritual number select,avoid virtual gpio set SMT.

s/gpio/GPIO/
s/vritual/virtual/

Virtual GPIOs you said here that means these pins only used inside SoC
and not being exported to outside SoC, right? It seems this kind of
pins doesn't need SMT.

>
> Signed-off-by: Chuanjia Liu <Chuanjia.Liu@xxxxxxxxxxxx>
> ---
>  drivers/pinctrl/mediatek/mtk-eint.h              |    1 +
>  drivers/pinctrl/mediatek/pinctrl-mt8183.c        |    1 +
>  drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c |    9 ++++++---
>  3 files changed, 8 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/pinctrl/mediatek/mtk-eint.h b/drivers/pinctrl/mediatek/mtk-eint.h
> index 48468d0..c16beaf 100644
> --- a/drivers/pinctrl/mediatek/mtk-eint.h
> +++ b/drivers/pinctrl/mediatek/mtk-eint.h
> @@ -37,6 +37,7 @@ struct mtk_eint_hw {
>         u8              ports;
>         unsigned int    ap_num;
>         unsigned int    db_cnt;
> +       unsigned int    vir_start;
>  };
>
>  struct mtk_eint;
> diff --git a/drivers/pinctrl/mediatek/pinctrl-mt8183.c b/drivers/pinctrl/mediatek/pinctrl-mt8183.c
> index 6262fd3..bbeafd3 100644
> --- a/drivers/pinctrl/mediatek/pinctrl-mt8183.c
> +++ b/drivers/pinctrl/mediatek/pinctrl-mt8183.c
> @@ -497,6 +497,7 @@
>         .ports     = 6,
>         .ap_num    = 212,
>         .db_cnt    = 13,
> +       .vir_start = 180,
>  };
>
>  static const struct mtk_pin_soc mt8183_data = {
> diff --git a/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c b/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c
> index 4a9e0d4..ca3bae1 100644
> --- a/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c
> +++ b/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c
> @@ -289,9 +289,12 @@ static int mtk_xt_set_gpio_as_eint(void *data, unsigned long eint_n)
>         if (err)
>                 return err;
>
> -       err = mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_SMT, MTK_ENABLE);
> -       if (err)
> -               return err;
> +       if (gpio_n < hw->eint->hw->vir_start) {
> +               err = mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_SMT,
> +                                      MTK_ENABLE);
> +               if (err)
> +                       return err;
> +       }

The changes will break these SoCs without a properly configured vir_start.

If SMT seems unnecessary for these kinds of virtual GPIOs pin in the
path, we can do it as

err = mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_SMT,
                                        MTK_ENABLE);
/* please add comments for the exclusion condition */
if (err && err != -ENOTSUPP)
        return err;

If there is getting much special on certain pins between SoCs, and
then we can consider creating a desc->flag to split logic.

>
>         return 0;
>  }
> --
> 1.7.9.5