Re: [PATCH] Staging: nvec: nvec: fixed check style issues

[Joe Perches]

On Sun, 2018-12-16 at 13:43 -0800, Amir Mahdi Ghorbanian wrote:
> Replaced udelay() by the preferred usleep_range() function.
[]
> diff --git a/drivers/staging/nvec/nvec.c b/drivers/staging/nvec/nvec.c
[]
> @@ -626,7 +626,7 @@ static irqreturn_t nvec_interrupt(int irq, void *dev)
>  		break;
>  	case 2:		/* first byte after command */
>  		if (status == (I2C_SL_IRQ | RNW | RCVD)) {
> -			udelay(33);
> +			usleep_range(0, 33);

Umm, this is not the same outcome.

udelay delays a minimum of 33 usecs.
usleep_range delays from min to max usecs.


kernel/time/timer.c: * usleep_range - Sleep for an approximate time
kernel/time/timer.c- * @min: Minimum time in usecs to sleep
kernel/time/timer.c- * @max: Maximum time in usecs to sleep
kernel/time/timer.c- *
kernel/time/timer.c- * In non-atomic context where the exact wakeup time is flexible, use
kernel/time/timer.c: * usleep_range() instead of udelay().  The sleep improves responsiveness
kernel/time/timer.c- * by avoiding the CPU-hogging busy-wait of udelay(), and the range reduces
kernel/time/timer.c- * power usage by allowing hrtimers to take advantage of an already-
kernel/time/timer.c- * scheduled interrupt instead of scheduling a new one just for this sleep.
kernel/time/timer.c- */

>  			if (nvec->rx->data[0] != 0x01) {
>  				dev_err(nvec->dev,
>  					"Read without prior read command\n");
> @@ -713,7 +713,7 @@ static irqreturn_t nvec_interrupt(int irq, void *dev)
>  	 * We experience less incomplete messages with this delay than without
>  	 * it, but we don't know why. Help is appreciated.
>  	 */
> -	udelay(100);
> +	usleep_range(0, 100);

here too.