Re: [PATCH 2/2] PCI: mediatek: Add controller support for MT7629

[Lorenzo Pieralisi]

On Tue, Dec 18, 2018 at 05:19:24PM +0800, Jianjun Wang wrote:
> On Mon, 2018-12-17 at 15:46 +0000, Lorenzo Pieralisi wrote:
> > On Mon, Dec 17, 2018 at 08:32:47AM -0600, Bjorn Helgaas wrote:
> > > On Mon, Dec 17, 2018 at 04:19:39PM +0800, Jianjun Wang wrote:
> > > > On Thu, 2018-12-13 at 08:55 -0600, Bjorn Helgaas wrote:
> > > > > On Thu, Dec 06, 2018 at 09:09:13AM +0800, Jianjun Wang wrote:
> > > > > > The read value of BAR0 is 0xffff_ffff, it's size will be calculated as 4GB
> > > > > > in arm64 but bogus alignment values at arm32, the pcie device and devices
> > > > > > behind this bridge will not be enabled. Fix it's BAR0 resource size to
> > > > > > guarantee the pcie devices will be enabled correctly.
> > > > > 
> > > > > So this is a hardware erratum?  Per spec, a memory BAR has bit 0 hardwired
> > > > > to 0, and an IO BAR has bit 1 hardwired to 0.
> > > > 
> > > > Yes, it only works properly on 64bit platform.
> > > 
> > > I don't understand.  BARs are supposed to work the same regardless of
> > > whether it's a 32- or 64-bit platform.  If this is a workaround for a
> > > hardware defect, please just say that explicitly.
> > 
> > I do not understand this either. First thing to do is to describe the
> > problem properly so that we can actually find a solution to it.
> > 
> > Lorenzo
> 
> This BAR0 is a 64-bit memory BAR, the HW default values for this BAR is
> 0xffff_ffff_0000_0000 and it could not be changed except by config write
> operation.
> 
> The calculated BAR size will be 0 in 32-bit platform since the
> phys_addr_t is a 32bit value in 32-bit platform.
> 
> Actually MediaTek's HW does not using this BAR0, just omit it when
> assign resource is totally fine.
> 
> When assign the resource for each device, software will check the
> resource alignment first, and the resource of length zero will be
> regarded as a bogus alignment resource, it will be ignored and won't
> claim a resource parent for it.
> 
> When drivers try to enable the PCIe devices, the software will enable
> it's resources, but it will return an error number when found a
> unclaimed resource, in that case, the flow of enable devices will be
> interrupted and PCIe devices won't work properly.

As a starting point, please provide kernel logs for both 64-bit and
32-bit platforms (without this patch applied) and also a:

cat /proc/iomem

and

lspci

output for both configurations.

Thanks,
Lorenzo