[PATCH AUTOSEL 4.14 55/59] gpio: mvebu: only fail on missing clk if pwm is actually to be used
From: Sasha Levin
Date: Wed Dec 26 2018 - 17:42:12 EST
From: Uwe Kleine-KÃnig <u.kleine-koenig@xxxxxxxxxxxxxx>
[ Upstream commit c8da642d41a6811c21177c9994aa7dc35be67d46 ]
The gpio IP on Armada 370 at offset 0x18180 has neither a clk nor pwm
registers. So there is no need for a clk as the pwm isn't used anyhow.
So only check for the clk in the presence of the pwm registers. This fixes
a failure to probe the gpio driver for the above mentioned gpio device.
Fixes: 757642f9a584 ("gpio: mvebu: Add limited PWM support")
Signed-off-by: Uwe Kleine-KÃnig <u.kleine-koenig@xxxxxxxxxxxxxx>
Reviewed-by: Gregory CLEMENT <gregory.clement@xxxxxxxxxxx>
Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
drivers/gpio/gpio-mvebu.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/gpio/gpio-mvebu.c b/drivers/gpio/gpio-mvebu.c
index 45c65f805fd6..be85d4b39e99 100644
--- a/drivers/gpio/gpio-mvebu.c
+++ b/drivers/gpio/gpio-mvebu.c
@@ -777,9 +777,6 @@ static int mvebu_pwm_probe(struct platform_device *pdev,
"marvell,armada-370-gpio"))
return 0;
- if (IS_ERR(mvchip->clk))
- return PTR_ERR(mvchip->clk);
-
/*
* There are only two sets of PWM configuration registers for
* all the GPIO lines on those SoCs which this driver reserves
@@ -790,6 +787,9 @@ static int mvebu_pwm_probe(struct platform_device *pdev,
if (!res)
return 0;
+ if (IS_ERR(mvchip->clk))
+ return PTR_ERR(mvchip->clk);
+
/*
* Use set A for lines of GPIO chip with id 0, B for GPIO chip
* with id 1. Don't allow further GPIO chips to be used for PWM.
--
2.19.1