Re: [PATCH v3] pinctrl:mediatek:add EINT support to virtual GPIOs
From: Sean Wang
Date: Thu Dec 27 2018 - 14:22:10 EST
On Mon, Dec 24, 2018 at 8:25 PM <chuanjia.liu@xxxxxxxxxxxx> wrote:
>
> From: Chuanjia Liu <Chuanjia.Liu@xxxxxxxxxxxx>
>
there are still some nitpicks
an empty char should follow the ':' char
> Virtual gpio only used inside SOC and not being exported to outside SOC.
> Some modules use virtual gpio as eint and doesn't nedd SMT.
s/nedd/need/
> So this patch add EINT support to virtual GPIOs.
>
> Signed-off-by: Chuanjia Liu <Chuanjia.Liu@xxxxxxxxxxxx>
> ---
> change note:
> v3 : 1. modify subject and description
> 2. modify comments
> ---
> drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c | 10 +++++++++-
> 1 file changed, 9 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c b/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c
> index 4a9e0d4c2bbc..a0db145f798d 100644
> --- a/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c
> +++ b/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c
> @@ -290,7 +290,15 @@ static int mtk_xt_set_gpio_as_eint(void *data, unsigned long eint_n)
> return err;
>
> err = mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_SMT, MTK_ENABLE);
> - if (err)
> + /*
merge the second line to be consistent with the other comment blocks
> + *SMT is supposed to be supported by every real GPIO and doesn't
an empty char should follow '*' char to be consistent with the other
comment blocks
and also in the other lines starting with '*'
> + *support virtual GPIOs, so the extra condition err != -ENOTSUPP
> + *is just for adding EINT support to these virtual GPIOs. It should
> + *add an extra flag in the pin descriptor when more pins with
> + *distinctive characteristic come out.
> + */
> +
remove the blank line
> + if (err && err != -ENOTSUPP)
> return err;
>
> return 0;
> --
> 2.19.1
>