Re: [PATCH RFC 3/4] barriers: convert a control to a data dependency

[Michael S. Tsirkin]

On Mon, Jan 07, 2019 at 04:54:23PM +0100, Peter Zijlstra wrote:
> On Mon, Jan 07, 2019 at 08:36:36AM -0500, Michael S. Tsirkin wrote:
> > On Mon, Jan 07, 2019 at 10:46:10AM +0100, Peter Zijlstra wrote:
> 
> > > How about naming the thing: dependent_ptr() ? That is without any (r)mb
> > > implications at all. The address dependency is strictly weaker than an
> > > rmb in that it will only order the two loads in qestion and not, like
> > > rmb, any prior to any later load.
> > 
> > So I'm fine with this as it's enough for virtio, but I would like to point out two things:
> > 
> > 1. E.g. on x86 both SMP and DMA variants can be NOPs but
> > the madatory one can't, so assuming we do not want
> > it to be stronger than rmp then either we want
> > smp_dependent_ptr(), dma_dependent_ptr(), dependent_ptr()
> > or we just will specify that dependent_ptr() works for
> > both DMA and SMP.
> 
> The latter; the construct simply generates dependent loads. It is up to
> the CPU as to what all that works for.

But not on intel right? On intel loads are ordered so it can be a nop.

> > 2. Down the road, someone might want to order a store after a load.
> > Address dependency does that for us too. Assuming we make
> > dependent_ptr a NOP on x86, we will want an mb variant
> > which isn't a NOP on x86. Will we want to rename
> > dependent_ptr to dependent_ptr_rmb at that point?
> 
> Not sure; what is the actual overhead of the construct on x86 vs the
> NOP?

I'll have to check. There's a pipeline stall almost for sure - that's
why we put it there after all :).

-- 
MST