[PATCH v3 11/15] dt-bindings: PCI: aardvark: Describe the reset-gpios property

[Miquel Raynal]

A GPIO might be used to reset the PCI IP. Describe the property needed
in this case.

Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
---
 Documentation/devicetree/bindings/pci/aardvark-pci.txt | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/Documentation/devicetree/bindings/pci/aardvark-pci.txt b/Documentation/devicetree/bindings/pci/aardvark-pci.txt
index 8b7f048705ec..b47d6d608ae1 100644
--- a/Documentation/devicetree/bindings/pci/aardvark-pci.txt
+++ b/Documentation/devicetree/bindings/pci/aardvark-pci.txt
@@ -27,6 +27,8 @@ The following are optional properties:
  - pinctrl-names: must be "default".
  - pinctrl-0: pin control group to be used to mux the PCIe endpoint card
    reset line so that it will be automatically driven by the PCIe IP.
+ - reset-gpios: GPIO to reset the device (alternative to the above
+   entries that represent a pin controlled by the PCI IP itself).
 
 In addition, the Device Tree describing an Aardvark PCIe controller
 must include a sub-node that describes the legacy interrupt controller
-- 
2.19.1