Re: [PATCH v3] arm64: dts: meson: Fix mmc cd-gpios polarity

[Kevin Hilman]

Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> writes:

> Hi,
>
> some nit-picks as well as my Tested-by (in case it's not too late) below.
> thank you for taking care of this!
>
> On Thu, Jan 10, 2019 at 4:40 PM Loys Ollivier <lollivier@xxxxxxxxxxxx> wrote:
>>
>> Commit 89a5e15bcba8 ("gpio/mmc/of: Respect polarity in the device tree")
>> changed the behavior of "cd-inverted" to follow the device tree bindings
>> specification.
>> Lines specifying "cd-inverted" are now "active high".
> this depends on the polarity from the cd-gpios property. above commit
> caused cd-inverted to be applied twice (effectively making it a
> no-op). thus "cd-inverted" only means "active high" if cd-gpios also
> sets GPIO_ACTIVE_HIGH. if the polarity in cd-gpios is GPIO_ACTIVE_LOW
> together with "cd-inverted" then the GPIO will be treated as active
> low.
>
>> Fix the SD card for meson by setting the cd-gpios as "active low" according
>> to the boards specifications.
> not only switching to GPIO_ACTIVE_LOW, also dropping "cd-inverted"
>
>> Fixes: 89a5e15bcba8 ("gpio/mmc/of: Respect polarity in the device tree")
> in my patches for the 32-bit boards I used the commit which added SD
> card support to the board for the Fixes tag. however, I'm fine with
> this as well (I just wanted to point out that there's a small
> difference in our commits).
>
>> Signed-off-by: Loys Ollivier <lollivier@xxxxxxxxxxxx>
> on my Khadas VIM(1), using Kevin's v5.0/fixes branch:
> Tested-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>

I can add this tested-by tag in my v5.0/fixes branch for now, and can
replace it with a follow up if Loys can update the changelog with your
suggestions/clarifications.

Thanks,

Kevin