Re: [PATCH] USB: serial: cp210x: Fix GPIO in autosuspend

[Johan Hovold]

On Tue, Jan 15, 2019 at 09:17:58AM +0000, Karoly Pados wrote:
> > I think it's better to add the autopm call to gpio210x_gpio_get/set
> > only. This will allow for a simpler patch, and keeps the autopm handling
> > confined to the gpio paths.
> 
> I'll submit a v2.
> 
> >> @@ -1383,6 +1397,7 @@ static void cp210x_gpio_set(struct gpio_chip *gc, unsigned int gpio, int
> >> value)
> >> } else {
> >> u16 wIndex = buf.state << 8 | buf.mask;
> >> 
> >> + usb_autopm_get_interface(serial->interface);
> > 
> > Also make sure to always check for errors from autopm_get().
> 
> I checked everywhere else, the reason I didn't check here is on
> purpose based on your previous feedback. The caller function here
> doesn't have a return value, so the only way to return errors is to
> log, but in my last patch to ftdi_sio you made clear that errors from
> autopm_get shouldn't get logged. Trying to call usb_control_msg() even
> though the device could not wake does not cause issues, and the return
> value from usb_control_msg() clearly identifies the reason for failure
> (failure due to autosuspend), so error information is not lost either.
> So I thought not checking here has no real disadvantage and I still
> stay conformant to your previous guidance.

Ok, I understand your reasoning, but please do check for errors and bail
out early if autopm_get() fails. No need to log errors.

Thanks,
Johan