Re: broonie-regulator/for-next boot bisection: v5.0-rc2-20-g61b67608c6b9 on meson-gxl-s905x-libretech-cc

[Kevin Hilman]

Linus Walleij <linus.walleij@xxxxxxxxxx> writes:

> Thanks for this pretty impressive automated report!
>
> Maybe it will be hard to ask a robot to test changes! :D
>
> On Mon, Jan 14, 2019 at 11:04 PM kernelci.org bot <bot@xxxxxxxxxxxx> wrote:
>
>>   Target:     meson-gxl-s905x-libretech-cc
>
> I hope there is someone else with this board on CC since I don't
> know how to ask the robot to test patches.
>
> The log from the robot isn't super helpful as it does not have
> earlyprintk enabled and boot hangs before it gets to that (!)
> so no console messages.
>
> So I suppose this is:
> arch/arm64/boot/dts/amlogic/meson-gxl-s905x-libretech-cc.dts
> a pure device tree plattform which was added by Neil, so I hope
> he can test patches.
>
> And that has only one GPIO regulator, this one:
>
>         vcc_card: regulator-vcc-card {
>                 compatible = "regulator-gpio";
>
>                 regulator-name = "VCC_CARD";
>                 regulator-min-microvolt = <1800000>;
>                 regulator-max-microvolt = <3300000>;
>
>                 gpios = <&gpio_ao GPIOAO_3 GPIO_ACTIVE_HIGH>;
>                 gpios-states = <0>;
>
>                 states = <3300000 0>,
>                          <1800000 1>;
>
>                 regulator-settling-time-up-us = <200>;
>                 regulator-settling-time-down-us = <50000>;
>         };
>
> Meaning this is 3.3 V when that GPIO line is low, and 1.8V when that
> line is high, correct?
>
> That controls the VCC. This surely wouldn't block the boot process.
> So my code must be crashing completely. OK I will look closer at it
> and try to create a mock system of some sort.

Both Neil and I have access to this board, so we can test any fixes for
you.

Kevin