[PATCH 1/6] spi: bitbang: Don't call chipselect() in spi_bitbang_setup()

From: Alban Bedel
Date: Wed Jan 16 2019 - 13:56:04 EST


spi_setup() already call spi_set_cs() right after calling the
controller setup method, so there is no need for the bitbang driver to
do that. Because of this the chipselect() callback was confusingly
still called when CS is GPIO based.

Signed-off-by: Alban Bedel <albeu@xxxxxxx>
---
drivers/spi/spi-bitbang.c | 13 -------------
1 file changed, 13 deletions(-)

diff --git a/drivers/spi/spi-bitbang.c b/drivers/spi/spi-bitbang.c
index f29176000b8d..dd9a8c54a693 100644
--- a/drivers/spi/spi-bitbang.c
+++ b/drivers/spi/spi-bitbang.c
@@ -213,19 +213,6 @@ int spi_bitbang_setup(struct spi_device *spi)

dev_dbg(&spi->dev, "%s, %u nsec/bit\n", __func__, 2 * cs->nsecs);

- /* NOTE we _need_ to call chipselect() early, ideally with adapter
- * setup, unless the hardware defaults cooperate to avoid confusion
- * between normal (active low) and inverted chipselects.
- */
-
- /* deselect chip (low or high) */
- mutex_lock(&bitbang->lock);
- if (!bitbang->busy) {
- bitbang->chipselect(spi, BITBANG_CS_INACTIVE);
- ndelay(cs->nsecs);
- }
- mutex_unlock(&bitbang->lock);
-
return 0;
}
EXPORT_SYMBOL_GPL(spi_bitbang_setup);
--
2.19.1