Re: [PATCH v4 1/4] can: m_can: Create a m_can platform framework

[Dan Murphy]

Wolfgang

On 1/18/19 12:56 AM, Wolfgang Grandegger wrote:
> Hello Dan,
> 
> Am 17.01.19 um 21:08 schrieb Dan Murphy:
>> Wolfgang
>>
>> On 1/17/19 2:05 PM, Dan Murphy wrote:
>>> Create a m_can platform framework that peripherial
>>> devices can register to and use common code and register sets.
>>> The peripherial devices may provide read/write and configuration
>>> support of the IP.
>>>
>>> Signed-off-by: Dan Murphy <dmurphy@xxxxxx>
>>> ---
>>>  drivers/net/can/m_can/m_can.c          |   6 +
>>>  drivers/net/can/m_can/m_can_platform.c | 209 +++++++++++++++++++++++++
>>>  drivers/net/can/m_can/m_can_platform.h | 163 +++++++++++++++++++
>>>  3 files changed, 378 insertions(+)
>>>  create mode 100644 drivers/net/can/m_can/m_can_platform.c
>>>  create mode 100644 drivers/net/can/m_can/m_can_platform.h
>>>
> 
> ... snip ...
> 
>> This patch set is working for the TCAN and at least boots on io-mapped devices.
>> We have a couple of customers who are looking at using this implementation and we would like to
>> start moving this patch set along in the review.
>>
>> I did not put a change log in here as there have been no comments for the last 3 patch sets I sent.
>>
>> This v4 squashes a few bugs I found during testing across all the files.
> 
> OK, after a very busy week I will try to find time for the review...
> finally.
> 

Thanks.  I anticipate a v5 as we debug the io mapped code and continue to test the TCAN code.

Dan

> Thanks,
> 
> Wolfgang.
> 


-- 
------------------
Dan Murphy