Re: [PATCH] iio:potentiostat:lmp91000: solve codestyle WARNINGs and CHECKs

[Joe Perches]

On Tue, 2019-01-29 at 16:36 -0200, Lucas Oshiro wrote:
> Solve most of the checkpatch.pl WARNINGs and CHECKs on lmp9100.c. They
> are the following:
> 
> lmp91000.c:116: CHECK: Unnecessary parentheses around 'state != channel'
> lmp91000.c:116: CHECK: Unnecessary parentheses around 'channel == LMP91000_REG_MODECN_TEMP'
> lmp91000.c:214: CHECK: braces {} should be used on all arms of this statement
> lmp91000.c:216: CHECK: Unbalanced braces around else statement
> lmp91000.c:258: WARNING: line over 80 characters
> lmp91000.c:279: CHECK: Please don't use multiple blank lines

Some will say this is too many things to do at once.
I think it's mostly fine, but there are a few nits
that also could use fixing.

> diff --git a/drivers/iio/potentiostat/lmp91000.c b/drivers/iio/potentiostat/lmp91000.c
[]
> @@ -211,9 +211,9 @@ static int lmp91000_read_config(struct lmp91000_data *data)
>  
>  	ret = of_property_read_u32(np, "ti,tia-gain-ohm", &val);
>  	if (ret) {
> -		if (of_property_read_bool(np, "ti,external-tia-resistor"))
> +		if (of_property_read_bool(np, "ti,external-tia-resistor")) {
>  			val = 0;
> -		else {
> +		} else {
>  			dev_err(dev, "no ti,tia-gain-ohm defined");
>  			return ret;
>  		}

This could use inverting the test

	if (ret) {
		if (!of_property_read_bool(...)) {
			dev_err(dev, "no ti,ti-gain-ohm defined\n");
			return ret;
		}
		val = 0;
	}

Also the dev_err is missing a '\n' termination