[PATCH 07/10] arm64: dts: allwinner: h5: orange-pi-pc2: Add CPU regulator supply

[Chen-Yu Tsai]

The OrangePi PC 2 uses a Silergy SY8106A regulator to supply the CPU
cores. The fixed voltage when I2C programmed regulation is not in action
is slightly higher than 1.1V. The value in the device tree description
is based on calculations of the resistor values from the schematics.

Cc: Andre Przywara <andre.przywara@xxxxxxx>
Cc: Icenowy Zheng <icenowy@xxxxxxx>
Cc: Emmanuel Vadot <manu@xxxxxxxxxxx>
Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx>

---

This patch is based on the schematics and has not been tested on an
actual board.
---
 .../dts/allwinner/sun50i-h5-orangepi-pc2.dts  | 28 +++++++++++++++++++
 1 file changed, 28 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-pc2.dts b/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-pc2.dts
index 3e0d5a9c096d..23cfad7c78f4 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-pc2.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-pc2.dts
@@ -132,6 +132,10 @@
 	status = "okay";
 };
 
+&cpu0 {
+	cpu-supply = <&reg_vdd_cpux>;
+};
+
 &de {
 	status = "okay";
 };
@@ -207,6 +211,30 @@
 	status = "okay";
 };
 
+&r_i2c {
+	status = "okay";
+
+	reg_vdd_cpux: regulator@65 {
+		compatible = "silergy,sy8106a";
+		reg = <0x65>;
+		regulator-name = "vdd-cpux";
+		silergy,fixed-microvolt = <1108474>;
+		/*
+		 * The datasheet uses 1.1V as the minimum value of VDD-CPUX,
+		 * however both the Armbian DVFS table and the official one
+		 * have operating points with voltage under 1.1V, and both
+		 * DVFS table are known to work properly at the lowest
+		 * operating point.
+		 *
+		 * Use 1.0V as the minimum voltage instead.
+		 */
+		regulator-min-microvolt = <1000000>;
+		regulator-max-microvolt = <1300000>;
+		regulator-boot-on;
+		regulator-always-on;
+	};
+};
+
 &spi0  {
 	status = "okay";
 
-- 
2.20.1