Hi Alok,sure, will do.
Thanks for the patches!
On 1/22/19 08:33, Alok Chauhan wrote:
Add documentation for the interconnect and interconnect-names bindings
s/interconnect /interconnects /
for the GENI QUP as detailed by bindings/interconnect/interconnect.txt.
Signed-off-by: Alok Chauhan <alokc@xxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
index dab7ca9..44d7e02 100644
--- a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
+++ b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
@@ -17,6 +17,12 @@ Required properties if child node exists:
- #address-cells: Must be <1> for Serial Engine Address
- #size-cells: Must be <1> for Serial Engine Address Size
- ranges: Must be present
+- interconnects: phandle to a interconnect provider. Please refer
s/a interconnect/an interconnect/
sure
+ ../interconnect/interconnect.txt for details.
+ Must be 2 paths corresponding to 2 AXI ports.
+- interconnect-names: Port names to differentiate between the
+ 2 interconnect paths defined with interconnect
+ specifier.
Properties for children:
@@ -67,6 +73,10 @@ Example:
#size-cells = <1>;
ranges;
+ interconnects = <&qnoc 11 &qnoc 512>,
+ <&qnoc 0 &qnoc 543>;
Please take a snippet from your patch 6/6 and put it here instead of the
hard-coded integers above.
sure, will do this.
+ interconnect-names = "qup-memory", "qup-config";
+
i2c0: i2c@a94000 {
compatible = "qcom,geni-i2c";
reg = <0xa94000 0x4000>;
When you post a new version, please change the subject of the patch
series to PATCH v2, PATCH v3 etc, in order to be able to distinguish
between different versions.
Thanks,
Georgi