[PATCH 3/5] dt-bindings: leds: Add binding for axp20x-led device driver

[Stefan Mavrodiev]

This adds the devicetree bindings for charge led indicator found
on most of X-Powers AXP20X PMICs.

Signed-off-by: Stefan Mavrodiev <stefan@xxxxxxxxxx>
---
 .../devicetree/bindings/leds/leds-axp20x.txt  | 74 +++++++++++++++++++
 1 file changed, 74 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/leds/leds-axp20x.txt

diff --git a/Documentation/devicetree/bindings/leds/leds-axp20x.txt b/Documentation/devicetree/bindings/leds/leds-axp20x.txt
new file mode 100644
index 000000000000..73fae22ffe29
--- /dev/null
+++ b/Documentation/devicetree/bindings/leds/leds-axp20x.txt
@@ -0,0 +1,74 @@
+Device Tree Bindings for LED support on X-Powers PMIC
+
+Most of the X-Powers PMICs have integrated battery charger with LED indicator.
+The output is open-drain, so the state is either high-Z or output-low. The
+driver is subnode of AXP20X MFD driver, since it uses shared bus with all
+other cells.
+The LED can be controlled either manually or automatic. Then in automatic
+(controlled by the charger) there are two indication modes:
+
+Mode-A
+======
+- output-low:		Charging
+- high-Z		Not charging
+- 1Hz flashing:		Abnormal alarm
+- 4Hz flashing		Overvoltage alarm
+
+Mode-B
+======
+- output-low:		Battery full
+- high-Z		Not charging
+- 1Hz flashing:		Charging
+- 4Hz flashing		Overvoltage or abnormal alarm
+
+The control and the mode can be changed from sysfs.
+
+For AXP20X MFD bindings see:
+Documentation/devicetree/bindings/mfd/axp20x.txt
+
+Required properties:
+- compatible : Must be "x-powers,axp20x-led"
+
+Supported common leds properties, see ./common.txt for more information:
+- label : sets LED label. If omitted, dt device node is used
+- linux,default-trigger : See
+- default-state:
+
+Optional properties:
+- x-powers,charger-mode: 0 for Mode-A, 1 for Mode-B
+			 If omitted, then the control is set to manual mode.
+			 On invalid value, Mode-A is used.
+
+
+Example:
+
+	axp803: pmic@3a3 {
+		compatible = "x-powers,axp803";
+
+		...
+
+		axp20x-led {
+			compatible = "x-powers,axp20x-led";
+			status = "okay";
+
+			label = "axp20x:yellow:chgled";
+			linux,default-trigger = "timer";
+			default-state = "on";
+		};
+	};
+
+or
+
+	axp803: pmic@3a3 {
+		compatible = "x-powers,axp803";
+
+		...
+
+		axp20x-led {
+			compatible = "x-powers,axp20x-led";
+			status = "okay";
+
+			label = "axp20x:yellow:chgled";
+			x-powers,charger-mode = "mode-b";
+		};
+	};
-- 
2.17.1