Re: [PATCH v2 3/3] nvmem: zynqmp: Added zynqmp nvmem firmware driver

[Srinivas Kandagatla]

On 04/02/2019 07:09, Nava kishore Manne wrote:
>   
> -config SC27XX_EFUSE
> -	tristate "Spreadtrum SC27XX eFuse Support"
> -	depends on MFD_SC27XX_PMIC || COMPILE_TEST
> -	depends on HAS_IOMEM

Why are you removing SC27XX_EFUSE support here?

It does not look right!

> +config NVMEM_ZYNQMP
> +	bool "Xilinx ZYNQMP SoC nvmem firmware support"
> +	depends on ARCH_ZYNQMP
>   	help
> -	  This is a simple driver to dump specified values of Spreadtrum
> -	  SC27XX PMICs from eFuse.
> +	  This is a driver to access hardware related data like
> +	  soc revision, IDCODE... etc by using the firmware
> +	  interface.
>   
> -	  This driver can also be built as a module. If so, the module
> -	  will be called nvmem-sc27xx-efuse.
> +	  If sure, say yes. If unsure, say no.
>   
>   endif
> diff --git a/drivers/nvmem/Makefile b/drivers/nvmem/Makefile
> index 4e8c61628f1a..0b3abd7f5d02 100644
> --- a/drivers/nvmem/Makefile
> +++ b/drivers/nvmem/Makefile
> @@ -39,5 +39,6 @@ obj-$(CONFIG_NVMEM_SNVS_LPGPR)	+= nvmem_snvs_lpgpr.o
>   nvmem_snvs_lpgpr-y		:= snvs_lpgpr.o
>   obj-$(CONFIG_RAVE_SP_EEPROM)	+= nvmem-rave-sp-eeprom.o
>   nvmem-rave-sp-eeprom-y		:= rave-sp-eeprom.o
> -obj-$(CONFIG_SC27XX_EFUSE)	+= nvmem-sc27xx-efuse.o
> -nvmem-sc27xx-efuse-y		:= sc27xx-efuse.o

same here?

> +obj-$(CONFIG_NVMEM_ZYNQMP)     += nvmem_zynqmp_nvmem.o
> +nvmem_zynqmp_nvmem-y           := zynqmp_nvmem.o
> +

--srini