Re: [PATCH v2 11/15] dt-bindings: pinctrl: milbeaut: Add Milbeaut M10V pinctrl description

[Linus Walleij]

Hi Sugaya,

thanks for your patch!

On Fri, Feb 8, 2019 at 1:32 PM Sugaya Taichi
<sugaya.taichi@xxxxxxxxxxxxx> wrote:

> Add DT bindings document for Milbeaut M10V pinctrl.
>
> Signed-off-by: Sugaya Taichi <sugaya.taichi@xxxxxxxxxxxxx>

(...)
> +- interrupts: three interrupts specifer.
> +- interrupt-names: corresponds "interrupts" factor.
(...)
> +               interrupts = <0 54 4>, <0 55 4>, <0 56 4>, <0 57 4>,
> +                               <0 58 4>, <0 59 4>, <0 60 4>, <0 61 4>,
> +                               <0 62 4>, <0 63 4>, <0 64 4>, <0 65 4>,
> +                               <0 66 4>, <0 67 4>, <0 68 4>, <0 69 4>;
> +               interrupt-names = "pin-48", "pin-49", "pin-50", "pin-51",
> +                               "pin-52", "pin-53", "pin-54", "pin-55",
> +                               "pin-56", "pin-57", "pin-58", "pin-59",
> +                               "pin-60", "pin-61", "pin-62", "pin-63";

As mentioned in the review of the driver, don't do this.

This is a hierarchical interrupt controller, so these
GIC-offset-to-GPIO-interrupt-offests should be hardcoded in
the driver.

If these interrupt offsets differ between difference instances of
this pin controller, they should have different compatible strings.

Yours,
Linus Walleij