Re: [PATCH V18 6/6] i2c: tegra: add i2c interface timing support

[Wolfram Sang]

On Fri, Feb 08, 2019 at 10:59:42AM -0800, Sowjanya Komatineni wrote:
> This patch adds I2C interface timing registers support for
> proper bus rate configuration along with meeting the I2C spec
> setup and hold times based on the tuning performed on Tegra210,
> Tegra186 and Tegra194 platforms.
> 
> I2C_INTERFACE_TIMING_0 register contains TLOW and THIGH field
> and Tegra I2C controller design uses them as a part of internal
> clock divisor.
> 
> I2C_INTERFACE_TIMING_1 register contains the setup and hold times
> for start and stop conditions.
> 
> Acked-by: Thierry Reding <treding@xxxxxxxxxx>
> Reviewed-by: Dmitry Osipenko <digetx@xxxxxxxxx>
> Tested-by: Dmitry Osipenko <digetx@xxxxxxxxx>
> Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx>

Are you aware that we also have DT bindings for various I2C timing
values? They are usually board dependent and not so much SoC dependent.
Please check here:

Documentation/devicetree/bindings/i2c/i2c.txt

(Oops, I noticed 'i2c-sda-hold-time-ns' is missing from the docs. Will
fix that ASAP)

Just saying. The patch here is fine for me. DT support could be added
later, if you want that.

Attachment: signature.asc
Description: PGP signature