[PATCH v2 3/3] arm64: dts: imx8mq: Add the opp table and cores opp properties

From: Abel Vesa
Date: Fri Feb 15 2019 - 13:07:41 EST


Add the 0.8GHz and 1GHz opps. According to the datasheet:
https://www.nxp.com/docs/en/data-sheet/IMX8MDQLQIEC.pdf
section 3.1.3 Operating ranges.

The 0.8GHz opp runs in nominal mode with the regulator set to 0.9V.
The 1GHz runs in overdrive mode with the regulator set to 1V.

Signed-off-by: Abel Vesa <abel.vesa@xxxxxxx>
---
arch/arm64/boot/dts/freescale/imx8mq.dtsi | 23 +++++++++++++++++++++++
1 file changed, 23 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx8mq.dtsi b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
index 1a89062..ebdec9e 100644
--- a/arch/arm64/boot/dts/freescale/imx8mq.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
@@ -91,6 +91,7 @@
clocks = <&clk IMX8MQ_CLK_ARM>;
enable-method = "psci";
next-level-cache = <&A53_L2>;
+ operating-points-v2 = <&a53_0_opp_table>;
};

A53_1: cpu@1 {
@@ -101,6 +102,7 @@
clocks = <&clk IMX8MQ_CLK_ARM>;
enable-method = "psci";
next-level-cache = <&A53_L2>;
+ operating-points-v2 = <&a53_0_opp_table>;
};

A53_2: cpu@2 {
@@ -111,6 +113,7 @@
clocks = <&clk IMX8MQ_CLK_ARM>;
enable-method = "psci";
next-level-cache = <&A53_L2>;
+ operating-points-v2 = <&a53_0_opp_table>;
};

A53_3: cpu@3 {
@@ -121,6 +124,7 @@
clocks = <&clk IMX8MQ_CLK_ARM>;
enable-method = "psci";
next-level-cache = <&A53_L2>;
+ operating-points-v2 = <&a53_0_opp_table>;
};

A53_L2: l2-cache0 {
@@ -666,6 +670,25 @@
status = "disabled";
};

+
+ a53_0_opp_table: opp-table {
+ compatible = "operating-points-v2";
+ opp-shared;
+
+ opp-800000000 {
+ opp-hz = /bits/ 64 <800000000>;
+ opp-microvolt = <900000>;
+ clock-latency-ns = <150000>;
+ };
+
+ opp-1000000000 {
+ opp-hz = /bits/ 64 <1000000000>;
+ opp-microvolt = <1000000>;
+ clock-latency-ns = <150000>;
+ opp-suspend;
+ };
+ };
+
gic: interrupt-controller@38800000 {
compatible = "arm,gic-v3";
reg = <0x38800000 0x10000>, /* GIC Dist */
--
2.7.4