Re: [PATCH 2/8] dt-bindings: phy: Add Amlogic G12A USB3+PCIE Combo PHY Bindings
From: Neil Armstrong
Date: Mon Feb 18 2019 - 05:33:48 EST
On 17/02/2019 23:03, Martin Blumenstingl wrote:
> On Tue, Feb 12, 2019 at 4:15 PM Neil Armstrong <narmstrong@xxxxxxxxxxxx> wrote:
>>
>> Add the Amlogic G12A Family USB3 + PCIE Combo PHY Bindings.
>>
>> This PHY can provide exclusively USB3 or PCIE support on shared I/Os.
>>
>> Signed-off-by: Neil Armstrong <narmstrong@xxxxxxxxxxxx>
> one nit-pick below, but apart from that:
> Reviewed-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
>
>> ---
>> .../bindings/phy/meson-g12a-usb3-pcie-phy.txt | 25 +++++++++++++++++++
>> 1 file changed, 25 insertions(+)
>> create mode 100644 Documentation/devicetree/bindings/phy/meson-g12a-usb3-pcie-phy.txt
>>
>> diff --git a/Documentation/devicetree/bindings/phy/meson-g12a-usb3-pcie-phy.txt b/Documentation/devicetree/bindings/phy/meson-g12a-usb3-pcie-phy.txt
>> new file mode 100644
>> index 000000000000..714d751091f5
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/phy/meson-g12a-usb3-pcie-phy.txt
>> @@ -0,0 +1,25 @@
>> +* Amlogic G12A USB3 + PCIE Combo PHY binding
>> +
>> +Required properties:
>> +- compatible: Should be "amlogic,meson-g12a-usb3-pcie-phy"
>> +- #phys-cells: must be 1. The cell number is used to select the phy mode
>> + as defined in <dt-bindings/phy/phy.h> between PHY_TYPE_USB3 and PHY_TYPE_PCIE
>> +- reg: The base address and length of the registers
>> +- clocks: a phandle to the 100MHz reference clock of this PHY
>> +- clock-names: must be "ref_clk"
>> +- resets: phandle to the reset lines for:
>> + - the PHY control
>> + - the USB3+PCIE PHY
>> + - the PHY registers
> no reset-names (like in the G12A USB2 PHY bindings) here?
> even if you don't use them in the driver I suggest you add them for
> consistency (and maybe to make it easier to compare the bindings with
> the datasheet. I don't have access to the datasheet so I'm not sure if
> having the reset-names is relevant for this case)
You're right, it's better to have names here !
Neil
>
>
> Regards
> Martin
>