Re: [PATCH 1/4] dt-bindings: nvmem: Add STM32 factory-programmed romem
From: Fabrice Gasnier
Date: Mon Feb 18 2019 - 08:20:27 EST
On 1/30/19 5:38 PM, Fabrice Gasnier wrote:
> Add documentation for STMicroelectronics STM32 Factory-programmed
> read only memory area.
Hello Rob, DT Maintainers,
Gentlemen reminder for new DT bindings review.
Best Regards,
Fabrice
>
> Signed-off-by: Fabrice Gasnier <fabrice.gasnier@xxxxxx>
> ---
> .../devicetree/bindings/nvmem/st,stm32-romem.txt | 31 ++++++++++++++++++++++
> 1 file changed, 31 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/nvmem/st,stm32-romem.txt
>
> diff --git a/Documentation/devicetree/bindings/nvmem/st,stm32-romem.txt b/Documentation/devicetree/bindings/nvmem/st,stm32-romem.txt
> new file mode 100644
> index 0000000..fbff52e
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/nvmem/st,stm32-romem.txt
> @@ -0,0 +1,31 @@
> +STMicroelectronics STM32 Factory-programmed data device tree bindings
> +
> +This represents STM32 Factory-programmed read only non-volatile area: locked
> +flash, OTP, read-only HW regs... This contains various information such as:
> +analog calibration data for temperature sensor (e.g. TS_CAL1, TS_CAL2),
> +internal vref (VREFIN_CAL), unique device ID...
> +
> +Required properties:
> +- compatible: Should be one of:
> + "st,stm32-romem"
> + "st,stm32mp15-bsec"
> +- reg: Offset and length of factory-programmed area.
> +- #address-cells: Should be '<1>'.
> +- #size-cells: Should be '<1>'.
> +
> +Optional Data cells:
> +- Must be child nodes as described in nvmem.txt.
> +
> +Example on stm32f4:
> + romem: nvmem@1fff7800 {
> + compatible = "st,stm32-romem";
> + reg = <0x1fff7800 0x400>;
> + #address-cells = <1>;
> + #size-cells = <1>;
> +
> + /* Data cells: ts_cal1 at 0x1fff7a2c */
> + ts_cal1: calib@22c {
> + reg = <0x22c 0x2>;
> + };
> + ...
> + };
>