Re: [PATCH v2 13/15] ARM: dts: milbeaut: Add device tree set for the Milbeaut M10V board

[Sugaya, Taichi]

Hi,

On 2019/02/19 19:11, Arnd Bergmann wrote:
> On Tue, Feb 19, 2019 at 6:11 AM Sugaya, Taichi
> <sugaya.taichi@xxxxxxxxxxxxx> wrote:
> > Hi,
> > Thank you for you comments.
> >
> > On 2019/02/18 21:09, Arnd Bergmann wrote:
> > > On Fri, Feb 8, 2019 at 1:28 PM Sugaya Taichi
> > > <sugaya.taichi@xxxxxxxxxxxxx> wrote:
> > > > +
> > > > +       aliases {
> > > > +               serial1 = &uart1;
> > > > +       };
> > >
> > > Maybe start with serial0 here? It seems unusual to start
> > > counting at 1.
> >
> > The M10V evaluation board(EVB) uses a console with uart ch1, so this
> > alias number is derived from the used channel one.
> > Therefore it is no problem to change the alias number to 0.
>
> The alias should normally reflect whatever is printed on the board,
> if there are no labels, the convention is to start with zero, regardless
> of what internal uart is connected to it.

I got it.
I use a "serial0" beacause there are no labels about uart ch on M10V EVB.

Thanks,
Sugaya Taichi

>       Arnd