[PATCH net-next 09/15] net: mvpp2: always disable both MACs when disabling a port

[Antoine Tenart]

This patch modifies the port_disable() helper to always disable both the
GMAC and the XLG MAC when called. At boot time we do not know of a port
was enabled in the firmware/bootloader, and if so what mode was used
(hence which of the two MACs was used).

This also help in implementing a logic where all blocks are disabled
when not used, and only enabled regarding the current mode used on a
given port.

Signed-off-by: Antoine Tenart <antoine.tenart@xxxxxxxxxxx>
---
 drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
index 11284918d907..b27966355df9 100644
--- a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
+++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
@@ -1214,11 +1214,11 @@ static void mvpp2_port_disable(struct mvpp2_port *port)
 		/* Disable & reset should be done separately */
 		val &= ~MVPP22_XLG_CTRL0_MAC_RESET_DIS;
 		writel(val, port->base + MVPP22_XLG_CTRL0_REG);
-	} else {
-		val = readl(port->base + MVPP2_GMAC_CTRL_0_REG);
-		val &= ~(MVPP2_GMAC_PORT_EN_MASK);
-		writel(val, port->base + MVPP2_GMAC_CTRL_0_REG);
 	}
+
+	val = readl(port->base + MVPP2_GMAC_CTRL_0_REG);
+	val &= ~(MVPP2_GMAC_PORT_EN_MASK);
+	writel(val, port->base + MVPP2_GMAC_CTRL_0_REG);
 }
 
 /* Set IEEE 802.3x Flow Control Xon Packet Transmission Mode */
-- 
2.20.1