Re: [PATCH v6 5/6] i2c: mediatek: Add i2c support for MediaTek MT8183

From: Nicolas Boichat
Date: Mon Mar 11 2019 - 04:35:09 EST

On Mon, Mar 11, 2019 at 1:41 PM Qii Wang <qii.wang@xxxxxxxxxxxx> wrote:
>
> Add i2c compatible for MT8183. Compare to MT2712 i2c controller,
> MT8183 has different register offsets. Ltiming_reg is added to
> adjust low width of SCL. Arb clock and dma_sync are needed.
>
> Signed-off-by: Qii Wang <qii.wang@xxxxxxxxxxxx>

LTIMING support could be split as yet-another-subpatch, but otherwise LGTM.

Reviewed-by: Nicolas Boichat <drinkcat@xxxxxxxxxxxx>

> ---
> drivers/i2c/busses/i2c-mt65xx.c | 62 +++++++++++++++++++++++++++++++++++++--
> 1 file changed, 60 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/i2c/busses/i2c-mt65xx.c b/drivers/i2c/busses/i2c-mt65xx.c
> index 6137ad7..745b0d0 100644
> --- a/drivers/i2c/busses/i2c-mt65xx.c
> +++ b/drivers/i2c/busses/i2c-mt65xx.c
> @@ -133,6 +133,7 @@ enum I2C_REGS_OFFSET {
> OFFSET_DEBUGCTRL,
> OFFSET_TRANSFER_LEN_AUX,
> OFFSET_CLOCK_DIV,
> + OFFSET_LTIMING,
> };
>
> static const u16 mt_i2c_regs_v1[] = {
> @@ -162,6 +163,32 @@ enum I2C_REGS_OFFSET {
> [OFFSET_CLOCK_DIV] = 0x70,
> };
>
> +static const u16 mt_i2c_regs_v2[] = {
> + [OFFSET_DATA_PORT] = 0x0,
> + [OFFSET_SLAVE_ADDR] = 0x4,
> + [OFFSET_INTR_MASK] = 0x8,
> + [OFFSET_INTR_STAT] = 0xc,
> + [OFFSET_CONTROL] = 0x10,
> + [OFFSET_TRANSFER_LEN] = 0x14,
> + [OFFSET_TRANSAC_LEN] = 0x18,
> + [OFFSET_DELAY_LEN] = 0x1c,
> + [OFFSET_TIMING] = 0x20,
> + [OFFSET_START] = 0x24,
> + [OFFSET_EXT_CONF] = 0x28,
> + [OFFSET_LTIMING] = 0x2c,
> + [OFFSET_HS] = 0x30,
> + [OFFSET_IO_CONFIG] = 0x34,
> + [OFFSET_FIFO_ADDR_CLR] = 0x38,
> + [OFFSET_TRANSFER_LEN_AUX] = 0x44,
> + [OFFSET_CLOCK_DIV] = 0x48,
> + [OFFSET_SOFTRESET] = 0x50,
> + [OFFSET_DEBUGSTAT] = 0xe0,
> + [OFFSET_DEBUGCTRL] = 0xe8,
> + [OFFSET_FIFO_STAT] = 0xf4,
> + [OFFSET_FIFO_THRESH] = 0xf8,
> + [OFFSET_DCM_EN] = 0xf88,
> +};
> +
> struct mtk_i2c_compatible {
> const struct i2c_adapter_quirks *quirks;
> const u16 *regs;
> @@ -172,6 +199,7 @@ struct mtk_i2c_compatible {
> unsigned char support_33bits: 1;
> unsigned char timing_adjust: 1;
> unsigned char dma_sync: 1;
> + unsigned char ltiming_adjust: 1;
> };
>
> struct mtk_i2c {
> @@ -195,6 +223,7 @@ struct mtk_i2c {
> enum mtk_trans_op op;
> u16 timing_reg;
> u16 high_speed_reg;
> + u16 ltiming_reg;
> unsigned char auto_restart;
> bool ignore_restart_irq;
> const struct mtk_i2c_compatible *dev_comp;
> @@ -222,6 +251,7 @@ struct mtk_i2c {
> .support_33bits = 1,
> .timing_adjust = 1,
> .dma_sync = 0,
> + .ltiming_adjust = 0,
> };
>
> static const struct mtk_i2c_compatible mt6577_compat = {
> @@ -234,6 +264,7 @@ struct mtk_i2c {
> .support_33bits = 0,
> .timing_adjust = 0,
> .dma_sync = 0,
> + .ltiming_adjust = 0,
> };
>
> static const struct mtk_i2c_compatible mt6589_compat = {
> @@ -246,6 +277,7 @@ struct mtk_i2c {
> .support_33bits = 0,
> .timing_adjust = 0,
> .dma_sync = 0,
> + .ltiming_adjust = 0,
> };
>
> static const struct mtk_i2c_compatible mt7622_compat = {
> @@ -258,6 +290,7 @@ struct mtk_i2c {
> .support_33bits = 0,
> .timing_adjust = 0,
> .dma_sync = 0,
> + .ltiming_adjust = 0,
> };
>
> static const struct mtk_i2c_compatible mt8173_compat = {
> @@ -269,6 +302,19 @@ struct mtk_i2c {
> .support_33bits = 1,
> .timing_adjust = 0,
> .dma_sync = 0,
> + .ltiming_adjust = 0,
> +};
> +
> +static const struct mtk_i2c_compatible mt8183_compat = {
> + .regs = mt_i2c_regs_v2,
> + .pmic_i2c = 0,
> + .dcm = 0,
> + .auto_restart = 1,
> + .aux_len_reg = 1,
> + .support_33bits = 1,
> + .timing_adjust = 1,
> + .dma_sync = 1,
> + .ltiming_adjust = 1,
> };
>
> static const struct of_device_id mtk_i2c_of_match[] = {
> @@ -277,6 +323,7 @@ struct mtk_i2c {
> { .compatible = "mediatek,mt6589-i2c", .data = &mt6589_compat },
> { .compatible = "mediatek,mt7622-i2c", .data = &mt7622_compat },
> { .compatible = "mediatek,mt8173-i2c", .data = &mt8173_compat },
> + { .compatible = "mediatek,mt8183-i2c", .data = &mt8183_compat },
> {}
> };
> MODULE_DEVICE_TABLE(of, mtk_i2c_of_match);
> @@ -361,6 +408,8 @@ static void mtk_i2c_init_hw(struct mtk_i2c *i2c)
>
> mtk_i2c_writew(i2c, i2c->timing_reg, OFFSET_TIMING);
> mtk_i2c_writew(i2c, i2c->high_speed_reg, OFFSET_HS);
> + if (i2c->dev_comp->ltiming_adjust)
> + mtk_i2c_writew(i2c, i2c->ltiming_reg, OFFSET_LTIMING);
>
> /* If use i2c pin from PMIC mt6397 side, need set PATH_DIR first */
> if (i2c->have_pmic)
> @@ -460,6 +509,8 @@ static int mtk_i2c_set_speed(struct mtk_i2c *i2c, unsigned int parent_clk)
> unsigned int clk_src;
> unsigned int step_cnt;
> unsigned int sample_cnt;
> + unsigned int l_step_cnt;
> + unsigned int l_sample_cnt;
> unsigned int target_speed;
> int ret;
>
> @@ -469,11 +520,11 @@ static int mtk_i2c_set_speed(struct mtk_i2c *i2c, unsigned int parent_clk)
> if (target_speed > MAX_FS_MODE_SPEED) {
> /* Set master code speed register */
> ret = mtk_i2c_calculate_speed(i2c, clk_src, MAX_FS_MODE_SPEED,
> - &step_cnt, &sample_cnt);
> + &l_step_cnt, &l_sample_cnt);
> if (ret < 0)
> return ret;
>
> - i2c->timing_reg = (sample_cnt << 8) | step_cnt;
> + i2c->timing_reg = (l_sample_cnt << 8) | l_step_cnt;
>
> /* Set the high speed mode register */
> ret = mtk_i2c_calculate_speed(i2c, clk_src, target_speed,
> @@ -483,6 +534,10 @@ static int mtk_i2c_set_speed(struct mtk_i2c *i2c, unsigned int parent_clk)
>
> i2c->high_speed_reg = I2C_TIME_DEFAULT_VALUE |
> (sample_cnt << 12) | (step_cnt << 8);
> +
> + if (i2c->dev_comp->ltiming_adjust)
> + i2c->ltiming_reg = (l_sample_cnt << 6) | l_step_cnt |
> + (sample_cnt << 12) | (step_cnt << 9);
> } else {
> ret = mtk_i2c_calculate_speed(i2c, clk_src, target_speed,
> &step_cnt, &sample_cnt);
> @@ -493,6 +548,9 @@ static int mtk_i2c_set_speed(struct mtk_i2c *i2c, unsigned int parent_clk)
>
> /* Disable the high speed transaction */
> i2c->high_speed_reg = I2C_TIME_CLR_VALUE;
> +
> + if (i2c->dev_comp->ltiming_adjust)
> + i2c->ltiming_reg = (sample_cnt << 6) | step_cnt;
> }
>
> return 0;
> --
> 1.7.9.5
>