[PATCH v9] Add basic and clock support for Mediatek MT8183 SoC

[Erin Lo]

MT8183 is a SoC based on 64bit ARMv8 architecture.
It contains 4 CA53 and 4 CA73 cores.
MT8183 share many HW IP with MT65xx series.
This patchset was tested on MT8183 evaluation board and use correct clock to shell.

Based on v5.1-rc1 and
http://lists.infradead.org/pipermail/linux-mediatek/2019-March/017963.html

Change in v9:
Remove pio node since binding is not documented yet

Change in v8:
1. Fix interrupt-parent of pio node
2. Remove pinfunc.h and spi node patches

Change in v7:
1. Place all the MMIO peripherals under one or more simple-bus nodes
2. Make the pinfunc.h and spi node into seperate patch
3. Modify SPIs pamerater from 4 back to 3
   and remove patch "support 4 interrupt parameters for sysirq"
4. Rename intpol-controller to interrupt-controller
5. Rename pinctrl@1000b000 to pinctrl@10005000

Change in v6:
1. Remove power and iommu nodes
2. Fix dtb build warning
3. Fix pinctrl binding doc
4. Fix '_' in node names

Change in v5:
1. Collect all device tree nodes to the last patch
2. Add PMU
3. Add Signed-off-by
4. Remove clock driver code and binding doc
5. Add pinctrl, iommu, spi, and pwrap nodes

Change in v4:
1. Correct syntax error in dtsi
2. Add MT8183 clock support

Change in v3:
1. Fill out GICC, GICH, GICV regions
2. Update Copyright to 2018

Change in v2:
1. Split dt-bindings into different patches
2. Correct bindings for supported SoCs (mtk-uart.txt)

Ben Ho (1):
  arm64: dts: Add Mediatek SoC MT8183 and evaluation board dts and
    Makefile

 arch/arm64/boot/dts/mediatek/Makefile       |   1 +
 arch/arm64/boot/dts/mediatek/mt8183-evb.dts |  31 +++
 arch/arm64/boot/dts/mediatek/mt8183.dtsi    | 311 ++++++++++++++++++++++++++++
 3 files changed, 343 insertions(+)
 create mode 100644 arch/arm64/boot/dts/mediatek/mt8183-evb.dts
 create mode 100644 arch/arm64/boot/dts/mediatek/mt8183.dtsi

--
1.9.1