Re: [PATCH 0/6] nvmem: sunxi_sid: native format and A83T/H5 support

[Srinivas Kandagatla]

On 18/03/2019 07:33, Chen-Yu Tsai wrote:
> From: Chen-Yu Tsai <wens@xxxxxxxx>
>
> Hi everyone,
>
> This series converts the sunxi_sid driver to read out data in native
> endianness for all Allwinner SoCs. It was already the case for the H3,
> which used a different read-out method. The endianness for this hardware
> was found to be either native or little endian [1], based on the data
> layout for the thermal sensor calibration data stored within. Some SoCs
> have either 1 or 3 sensors, and calibration data for each sensor is 2
> bytes wide, with data for 2 sensors packed into 1 word.
>
> The first three patches do some clean-up and improvements of the code
> overall. The fourth patch converts the driver to reading out data in
> native endianness. The fifth adds support for the A83T and H5. These
> two were already listed in the device tree bindings. The last patch
> adds a device node for it on H3 and H5.
>
> Please have a look.
>
> Regards
> ChenYu
>
> [1] https://lkml.org/lkml/2019/2/18/134
>
> Chen-Yu Tsai (6):
>    nvmem: sunxi_sid: Read out SID for randomness without looping
>    nvmem: sunxi_sid: Optimize register read-out method
>    nvmem: sunxi_sid: Dynamically allocate nvmem_config structure
>    nvmem: sunxi_sid: Read out data in native format
>    nvmem: sunxi_sid: Support SID on A83T and H5
>    ARM: dts: sunxi: h3/h5: Add device node for SID
Applied all the nvmem patches except DTS patch to nvmem next

Thanks,
srini