Re: [PATCH v2 3/5] devfreq: rk3399_dmc: Pass ODT and auto power down parameters to TF-A.
From: Matthias Kaehlcke
Date: Wed Mar 20 2019 - 18:02:27 EST
Hi GaÃl,
On Wed, Mar 20, 2019 at 05:50:13PM -0400, GaÃl PORTAY wrote:
> Hi Matthias,
>
> On Tue, Mar 19, 2019 at 05:33:52PM -0700, Matthias Kaehlcke wrote:
> > ...
> > > @@ -95,6 +103,19 @@ static int rk3399_dmcfreq_target(struct device *dev, unsigned long *freq,
> > >
> > > mutex_lock(&dmcfreq->lock);
> > >
> > > + if (target_rate >= dmcfreq->odt_dis_freq)
> > > + odt_enable = true;
> > > +
> > > + /*
> > > + * This makes a SMC call to the TF-A to set the DDR PD (power-down)
> > > + * timings and to enable or disable the ODT (on-die termination)
> > > + * resistors.
> > > + */
> > > + arm_smccc_smc(ROCKCHIP_SIP_DRAM_FREQ, dmcfreq->odt_pd_arg0,
> > > + dmcfreq->odt_pd_arg1,
> > > + ROCKCHIP_SIP_CONFIG_DRAM_SET_ODT_PD,
> > > + odt_enable, 0, 0, 0, &res);
> >
> > Is it necessary/desirable to make this call for every frequency
> > change? IIUC it should be only needed when odt_enable changes and the
> > driver could track the state. If the DDR frequency doesn't change too
> > often and the overhead of the call is small it shouldn't be really
> > important though.
> >
>
> I will test your solution first to make sure there is no regression to
> run that call for frequency change only.
If there is no frequency change the function returns at the
beginning. My suggestion was to only do the call when 'odt_enable'
changes, i.e. when a change (up or down) passes the 'odt_dis_freq'
threshold.
> Also, the call takes around 300us.
Thanks for the info!
Matthias