Re: Re: [PATCH] pinctrl: intel: Implements gpio free function

[Mika Westerberg]

On Thu, Mar 21, 2019 at 09:35:26PM +0800, zhuchangchun@xxxxxxxx wrote:
>    --> I know your meaning, even though I've did following actions
>    instead of unexport,
> 
>    # echo 0 > /sys/class/gpio/gpioXX/value
>      # echo in > /sys/class/gpio/gpioXX/direction
> 
>    the padcfg0 value still can not roll back,because after export the
>    gpio,the following
> 
>    action as padcfg0 settings was done.
> 
>    Exactly  TX and RX register have been set as below in GPIO request:
> 
>    /* Disable TX buffer and enable RX (this will be input) */
> 
>    value &= ~PADCFG0_GPIORXDIS;
> 
>    value |= PADCFG0_GPIOTXDIS;
> 
>    this will infruence next reboot gpio signal.
> 
>    And could you pls see my ->free function implementation?

I checked it and you do this:

+       value |= PADCFG0_GPIORXDIS;
+       value &= ~PADCFG0_GPIOTXDIS;

which pretty much turns the pin GPIO output unconditionally. I don't
really think it is good idea. May work in your case but may cause
problems with others.

If you want to keep it as output and leave the value 1 (high) before you
issue reboot, I don't think you need to do anything via sysfs (as the
pin is already in that state and issuing reboot command should not
change anything because the driver does not have ->shutdown callback.

In other words, your peripheral expects reset GPIO to be asserted (high)
during reboot so unless the boot firmware resets the pin I don't see why
leaving it as is does not work for you.