[PATCH V1 14/26] spi: tegra114: add 3 wire transfer mode support

[Sowjanya Komatineni]

This patch adds 3 wire transfer support to SPI mode list and also
implements it.

3 wire or Bi-directional mode uses only one serial data pin for
the transfer. SPI in master mode uses MOSI data line only and MISO
data line is not used by the SPI.

Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx>
---
 drivers/spi/spi-tegra114.c | 7 ++++++-
 1 file changed, 6 insertions(+), 1 deletion(-)

diff --git a/drivers/spi/spi-tegra114.c b/drivers/spi/spi-tegra114.c
index 335c594d5b74..01efb615a196 100644
--- a/drivers/spi/spi-tegra114.c
+++ b/drivers/spi/spi-tegra114.c
@@ -755,6 +755,11 @@ static u32 tegra_spi_setup_transfer_one(struct spi_device *spi,
 		else
 			command1 &= ~SPI_LSBIT_FE;
 
+		if (spi->mode & SPI_3WIRE)
+			command1 |= SPI_BIDIROE;
+		else
+			command1 &= ~SPI_BIDIROE;
+
 		if (tspi->cs_control) {
 			if (tspi->cs_control != spi)
 				tegra_spi_writel(tspi, command1, SPI_COMMAND1);
@@ -1148,7 +1153,7 @@ static int tegra_spi_probe(struct platform_device *pdev)
 
 	/* the spi->mode bits understood by this driver: */
 	master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH | SPI_LSB_FIRST |
-			    SPI_TX_DUAL | SPI_RX_DUAL;
+			    SPI_TX_DUAL | SPI_RX_DUAL | SPI_3WIRE;
 	master->setup = tegra_spi_setup;
 	master->transfer_one_message = tegra_spi_transfer_one_message;
 	master->num_chipselect = MAX_CHIP_SELECT;
-- 
2.7.4