Re: [PATCH v8 1/2] spi: Add Renesas R-Car Gen3 RPC-IF SPI controller driver

[Sergei Shtylyov]

Hello!

On 03/27/2019 04:32 AM, masonccyang@xxxxxxxxxxx wrote:

>> >>>> +static void rpc_spi_mem_set_prep_op_cfg(struct spi_device *spi,
>> >>>> +               const struct spi_mem_op *op,
>> >>>> +               u64 *offs, size_t *len)
>> >>>> +{
>> >>>> +   struct rpc_spi *rpc = spi_controller_get_devdata(spi->controller);
>> >>>
>> >>>> +   if (op->dummy.nbytes) {
>> >>>> +      rpc->smenr |= RPC_SMENR_DME;
>> >>>> +      rpc->dummy = RPC_SMDMCR_DMCYC(op->dummy.nbytes);
>> >>>
>> >>>    SMDMCR.DMCYC is in bits -- you forgot to multiply by 8.
>> >>
>> >> ?
>> >>
>> >> It's dummy cycles setting, i.e,. 0 is 1 cycle dummy and
>> >
>> >    Yeah, I should've written "cycles", sorry about that.
>>
>>    I also should've mentioned that w/o this change the "read SFDP" command
>> returns garbage and the flash doesn't work.
>>
> 
> Have you checked the dummy cycles setting with logical analysis ?

   I don't have a logic analyzer (if you meant it). However, I dumped all the registers
in your driver and Cogent's own driver, and SMDMCR was set to 0 in your driver and to
7 in our driver -- and only our driver then worked correctly.

> As datasheet mentioned it's dummy cycles depends on the transfer bit size setting = 1, 4 or 8.
> Setting RPC_SMDMCR_DMCYC(0x13) in 8 bits data width I got a 20 dummy cycles.
> Also confirmed these 20 dummy cycles by logical analysis equipment.

[...]

> best regards,
> Mason

MBR, Sergei