[PATCH AUTOSEL 5.0 260/262] gpio: of: Restrict enable-gpio quirk to regulator-gpio

[Sasha Levin]

From: Thierry Reding <treding@xxxxxxxxxx>

[ Upstream commit 692ef26e72fcce0c1e73c41683fd3512f3719d55 ]

Commit 0e7d6f940164 ("gpio: of: Apply regulator-gpio quirk only to
enable-gpios") breaks the device tree ABI specified in the device tree
bindings for fixed regulators (compatible "regulator-fixed"). According
to these bindings the polarity of the GPIO is exclusively controlled by
the presence or absence of the enable-active-high property. As such the
polarity quirk implemented in of_gpio_flags_quirks() must be applied to
the GPIO specified for fixed regulators.

However, commit 0e7d6f940164 ("gpio: of: Apply regulator-gpio quirk only
to enable-gpios") restricted the quirk to the enable-gpios property for
fixed regulators as well, whereas according to the commit message itself
it should only apply to "regulator-gpio" compatible device tree nodes.

Fix this by actually implementing what the offending commit intended,
which is to ensure that the quirk is applied to the GPIO specified by
the "enable-gpio" property for the "regulator-gpio" bindings only.

This fixes a regression on Jetson TX1 where the fixed regulator for the
HDMI +5V pin relies on the flags quirk for the proper polarity.

Fixes: 0e7d6f940164 ("gpio: of: Apply regulator-gpio quirk only to enable-gpios")
Signed-off-by: Thierry Reding <treding@xxxxxxxxxx>
Tested-by: Marek Vasut <marek.vasut@xxxxxxxxx>
Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
 drivers/gpio/gpiolib-of.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/gpiolib-of.c b/drivers/gpio/gpiolib-of.c
index 30542a10014f..a1dd2f1c0d02 100644
--- a/drivers/gpio/gpiolib-of.c
+++ b/drivers/gpio/gpiolib-of.c
@@ -84,10 +84,10 @@ static void of_gpio_flags_quirks(struct device_node *np,
 	 * Note that active low is the default.
 	 */
 	if (IS_ENABLED(CONFIG_REGULATOR) &&
-	    !strcmp(propname, "enable-gpio") &&
 	    (of_device_is_compatible(np, "regulator-fixed") ||
 	     of_device_is_compatible(np, "reg-fixed-voltage") ||
-	     of_device_is_compatible(np, "regulator-gpio"))) {
+	     (of_device_is_compatible(np, "regulator-gpio") &&
+	      strcmp(propname, "enable-gpio") == 0))) {
 		/*
 		 * The regulator GPIO handles are specified such that the
 		 * presence or absence of "enable-active-high" solely controls
-- 
2.19.1