Re: [PATCH RESEND v7 2/3] dt-bindings: phy: Add documentation for mixel dphy

[Guido Günther]

Hi Rob,

On Thu, Mar 28, 2019 at 11:57:29AM -0500, Rob Herring wrote:
> On Wed, Mar 27, 2019 at 09:20:00AM +0100, Guido Günther wrote:
> > Add support for the MIXEL DPHY IP as found in the NXP's i.MX8MQ.
> > 
> > Signed-off-by: Guido Günther <agx@xxxxxxxxxxx>
> > Reviewed-by: Sam Ravnborg <sam@xxxxxxxxxxxx>
> > ---
> >  .../bindings/phy/mixel,mipi-dsi-phy.txt       | 29 +++++++++++++++++++
> >  1 file changed, 29 insertions(+)
> >  create mode 100644 Documentation/devicetree/bindings/phy/mixel,mipi-dsi-phy.txt
> > 
> > diff --git a/Documentation/devicetree/bindings/phy/mixel,mipi-dsi-phy.txt b/Documentation/devicetree/bindings/phy/mixel,mipi-dsi-phy.txt
> > new file mode 100644
> > index 000000000000..d3646580412a
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/phy/mixel,mipi-dsi-phy.txt
> > @@ -0,0 +1,29 @@
> > +Mixel DSI PHY for i.MX8
> > +
> > +The Mixel MIPI-DSI PHY IP block is e.g. found on i.MX8 platforms (along the
> > +MIPI-DSI IP from Northwest Logic). It represents the physical layer for the
> > +electrical signals for DSI.
> > +
> > +Required properties:
> > +- compatible: Must be:
> > +  - "mixel,imx8mq-mipi-dphy"
> 
> If you had a fallback for mixel, then it would make sense, but as this 
> is imx8mq specifc 'fsl' should be the vendor prefix.

Fixed in v8.

> 
> > +- clocks: Must contain an entry for each entry in clock-names.
> > +- clock-names: Must contain the following entries:
> > +  - "phy_ref": phandle and specifier referring to the DPHY ref clock
> > +- reg: the register range of the PHY controller
> > +- #phy-cells: number of cells in PHY, as defined in
> > +  Documentation/devicetree/bindings/phy/phy-bindings.txt
> > +  this must be <0>
> > +
> > +Optional properties:
> > +- power-domains: phandle to power domain
> > +
> > +Example:
> > +	mipi_dphy: mipi_dphy@30A0030 {
> 
> mipi-dphy@... or just dphy@...

And this one as well.
Thanks for the review!
 -- Guido

>
> 
> > +		compatible = "mixel,imx8mq-mipi-dphy";
> > +		clocks = <&clk IMX8MQ_CLK_DSI_PHY_REF>;
> > +		clock-names = "phy_ref";
> > +		reg = <0x30A00300 0x100>;
> > +		power-domains = <&pd_mipi0>;
> > +		#phy-cells = <0>;
> > +        };
> > -- 
> > 2.20.1
> > 
>