Re: [PATCH] clocksource: timer-probe: change log level to info

[Daniel Lezcano]

On 16/04/2019 18:32, Moses Christopher wrote:
>   - In drivers/clocksource/timer-probe.c, the log level for the message
>     stating "no matching timers found" should be informational rather
>     than critical.
>   - Reference:
>      - https://e2e.ti.com/support/processors/f/791/t/726024

Thanks for the pointer.

Actually in most of the cases when there are no timers found after this
sequence it is because a definition is missing in the DT or the timer
was not able to initialize and we end up with a stuck board at boot time.

May be pr_warn would be more appropriate in this case.

However, if this omap board can boot without DT defined timers, does it
make sense to run the timer-probe code?


> Signed-off-by: Moses Christopher <moseschristopherb@xxxxxxxxx>
> ---
>  drivers/clocksource/timer-probe.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/clocksource/timer-probe.c b/drivers/clocksource/timer-probe.c
> index 028075720334..f0dcb41e079f 100644
> --- a/drivers/clocksource/timer-probe.c
> +++ b/drivers/clocksource/timer-probe.c
> @@ -50,5 +50,5 @@ void __init timer_probe(void)
>  	timers += acpi_probe_device_table(timer);
>  
>  	if (!timers)
> -		pr_crit("%s: no matching timers found\n", __func__);
> +		pr_info("%s: no matching timers found\n", __func__);
>  }
> 


-- 
 <http://www.linaro.org/> Linaro.org â Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog