[PATCH v2 1/3] dt-bindings: net: add qca,ar71xx.txt documentation
From: Oleksij Rempel
Date: Thu Apr 18 2019 - 01:26:44 EST
Add binding documentation for Atheros/QCA networking IP core used
in many routers.
Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
---
.../devicetree/bindings/net/qca,ar71xx.txt | 44 +++++++++++++++++++
1 file changed, 44 insertions(+)
create mode 100644 Documentation/devicetree/bindings/net/qca,ar71xx.txt
diff --git a/Documentation/devicetree/bindings/net/qca,ar71xx.txt b/Documentation/devicetree/bindings/net/qca,ar71xx.txt
new file mode 100644
index 000000000000..56abf224de2c
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/qca,ar71xx.txt
@@ -0,0 +1,44 @@
+Required properties:
+- compatible: Should be "qca,<soc>-eth". Currently support compatibles are:
+ qca,ar7100-eth - Atheros AR7100
+ qca,ar7240-eth - Atheros AR7240
+ qca,ar7241-eth - Atheros AR7241
+ qca,ar7242-eth - Atheros AR7242
+ qca,ar9130-eth - Atheros AR9130
+ qca,ar9330-eth - Atheros AR9330
+ qca,ar9340-eth - Atheros AR9340
+ qca,qca9530-eth - Qualcomm Atheros QCA9530
+ qca,qca9550-eth - Qualcomm Atheros QCA9550
+ qca,qca9560-eth - Qualcomm Atheros QCA9560
+
+- reg : Address and length of the register set for the device
+- interrupts : Should contain eth interrupt
+- phy-mode : See ethernet.txt file in the same directory
+- clocks: the clock used by the core
+- clock-names: the names of the clock listed in the clocks property. These are
+ "mdio".
+- resets: Should contain phandles to the reset signals
+- reset-names: Should contain the names of reset signal listed in the resets
+ property. These are "mac" and "mdio"
+
+Optional properties:
+- phy-handle : phandle to the PHY device connected to this device.
+- fixed-link : Assume a fixed link. See fixed-link.txt in the same directory.
+ Use instead of phy-handle.
+
+Optional subnodes:
+- mdio : specifies the mdio bus, used as a container for phy nodes
+ according to phy.txt in the same directory
+
+Example:
+
+ethernet@1a000000 {
+ compatible = "qca,ar9330-eth";
+ reg = <0x1a000000 0x200>;
+ interrupts = <5>;
+ resets = <&rst 13>, <&rst 23>;
+ reset-names = "mac", "mdio";
+ clocks = <&pll ATH79_CLK_MDIO>;
+ clock-names = "mdio";
+ phy-mode = "gmii";
+};
--
2.20.1