Re: [PATCH v3 2/2] dt-bindings: net: bluetooth: Add device property firmware-name for QCA6174

From: Rocky Liao
Date: Wed Apr 24 2019 - 02:19:13 EST


On 2019-04-24 01:06, Marcel Holtmann wrote:
Hi Rocky,

This patch adds an optional device property "firmware-name" to allow the
driver to load customized nvm firmware file based on this property.

Signed-off-by: Rocky Liao <rjliao@xxxxxxxxxxxxxx>
---
Changes in v3:
* added firmware-name instead of nvm-postfix to specify full firmware name
---
Documentation/devicetree/bindings/net/qualcomm-bluetooth.txt | 2 ++
1 file changed, 2 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/qualcomm-bluetooth.txt b/Documentation/devicetree/bindings/net/qualcomm-bluetooth.txt
index 824c0e2..2bcea50 100644
--- a/Documentation/devicetree/bindings/net/qualcomm-bluetooth.txt
+++ b/Documentation/devicetree/bindings/net/qualcomm-bluetooth.txt
@@ -16,6 +16,7 @@ Optional properties for compatible string qcom,qca6174-bt:

- enable-gpios: gpio specifier used to enable chip
- clocks: clock provided to the controller (SUSCLK_32KHZ)
+ - firmware-name: specify the name of nvm firmware to load

Required properties for compatible string qcom,wcn3990-bt:

@@ -39,6 +40,7 @@ serial@7570000 {

enable-gpios = <&pm8994_gpios 19 GPIO_ACTIVE_HIGH>;
clocks = <&divclk4>;
+ firmware-name = "nvm_00440302.bin";
};

and how is this a firmware-name property. Wouldnât this be more like
nvm-file or something along these lines. This really needs to be
cleared with Rob to pick the right property name.

Regards

Marcel

Hi Rob,

Are you OK to use a property name "nvm-file" or "firmware-nvm-file"? Actually we have two firmware files, one is the patch file which is common to all of the products, the other is the nvm file which is customized. Using a "nvm-file" or "firmware-nvm-file" property name would be more clear.

--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project