Re: [PATCH v6 1/3] backlight: lm3630a: return 0 on success in update_status functions

[Lee Jones]

On Thu, 02 May 2019, Daniel Thompson wrote:

> On Thu, May 02, 2019 at 06:42:39AM -0400, Brian Masney wrote:
> > On Thu, May 02, 2019 at 11:07:51AM +0100, Daniel Thompson wrote:
> > > On 24/04/2019 10:25, Brian Masney wrote:
> > > > lm3630a_bank_a_update_status() and lm3630a_bank_b_update_status()
> > > > both return the brightness value if the brightness was successfully
> > > > updated. Writing to these attributes via sysfs would cause a 'Bad
> > > > address' error to be returned. These functions should return 0 on
> > > > success, so let's change it to correct that error.
> > > > 
> > > > Signed-off-by: Brian Masney <masneyb@xxxxxxxxxxxxx>
> > > > Fixes: 28e64a68a2ef ("backlight: lm3630: apply chip revision")
> > > > Acked-by: Pavel Machek <pavel@xxxxxx>
> > > 
> > > Hi Brian, sorry for the delay. For some reason your mails are being dumped
> > > before they reach me so I only discovered these patches when I paid proper
> > > attention to the replies and fetched them from patchwork.
> > > 
> > > Hi Lee, is the same thing happening for you? ;-)
> > 
> > Huh, that's odd. I haven't ran into that issue when working with people
> > from Linaro in other subsystems.
> > 
> > As a sanity check, I used 'git send-email' to send this patch to
> > check-auth@xxxxxxxxxxxxxxxxxxx and it verified that I still have SPF,
> > DKIM, reverse DNS, etc. all setup properly on this domain.
> > 
> > hotmail.com addresses are the only ones I've had issues with in the
> > past, but I doubt you're forwarding your email there. :)
> 
> No... and strangely enough your recent e-mail sailed through just fine.
> Let's wait and see what is happening for Lee (which I suspect may not be
> until well into next week).

Just catching up now.  On first pass - only ~800 mails to go!

Looks like I do have Brian's mails though.

-- 
Lee Jones [æçæ]
Linaro Services Technical Lead
Linaro.org â Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog